BIOS may leave a TypeC PHY in a connected state even though the
corresponding port is disabled. This will prevent any hotplug events
from being signalled (after the monitor deasserts and then reasserts its
HPD) until the PHY is disconnected and so the driver will not detect a
connected sink. Rebooting with the PHY in the connected state also
results in a system hang.

Fix the above by disconnecting TypeC PHYs on disabled ports.

Before commit 64851a32 the PHY connected state was read out even
for disabled ports and later the PHY got disconnected as a side effect
of a tc_port_lock/unlock() sequence (during connector probing), hence
recovering the port's hotplug functionality.

Closes: https://gitlab.freedesktop.org/drm/intel/-/issues/5014
Fixes: 64851a32 ("drm/i915/tc: Add a mode for the TypeC PHY's disconnected state")
Cc: <stable@vger.kernel.org> # v5.16+
Cc: José Roberto de Souza <jose.souza@intel.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: José Roberto de Souza <jose.souza@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20220217152237.670220-1-imre.deak@intel.com
(cherry picked from commit ed0ccf34)
Signed-off-by: Tvrtko Ursulin <tvrtko.ursulin@intel.com>