• Mika Westerberg's avatar
    thunderbolt: Add support for host and device NVM firmware upgrade · e6b245cc
    Mika Westerberg authored
    Starting from Intel Falcon Ridge the NVM firmware can be upgraded by
    using DMA configuration based mailbox commands. If we detect that the
    host or device (device support starts from Intel Alpine Ridge) has the
    DMA configuration based mailbox we expose NVM information to the
    userspace as two separate Linux NVMem devices: nvm_active and
    nvm_non_active. The former is read-only portion of the active NVM which
    firmware upgrade tools can be use to find out suitable NVM image if the
    device identification strings are not enough.
    
    The latter is write-only portion where the new NVM image is to be
    written by the userspace. It is up to the userspace to find out right
    NVM image (the kernel does very minimal validation). The ICM firmware
    itself authenticates the new NVM firmware and fails the operation if it
    is not what is expected.
    
    We also expose two new sysfs files per each switch: nvm_version and
    nvm_authenticate which can be used to read the active NVM version and
    start the upgrade process.
    
    We also introduce safe mode which is the mode a switch goes when it does
    not have properly authenticated firmware. In this mode the switch only
    accepts a couple of commands including flashing a new NVM firmware image
    and triggering power cycle.
    
    This code is based on the work done by Amir Levy and Michael Jamet.
    Signed-off-by: default avatarMichael Jamet <michael.jamet@intel.com>
    Signed-off-by: default avatarMika Westerberg <mika.westerberg@linux.intel.com>
    Reviewed-by: default avatarYehezkel Bernat <yehezkel.bernat@intel.com>
    Reviewed-by: default avatarAndy Shevchenko <andriy.shevchenko@linux.intel.com>
    Signed-off-by: default avatarAndreas Noever <andreas.noever@gmail.com>
    Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
    e6b245cc
tb.c 10.9 KB