be2net: fix failure case in setting flow control

When the FW cmd to set flow control fails, the adapter state must simply
reflect the old values.
Signed-off-by: Kalesh AP <kalesh.purayil@emulex.com>
Signed-off-by: Sathya Perla <sathya.perla@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/emulex/benet/be_ethtool.c

@@ -705,15 +705,17 @@ be_set_pauseparam(struct net_device *netdev, struct ethtool_pauseparam *ecmd)
 
 	if (ecmd->autoneg != adapter->phy.fc_autoneg)
 		return -EINVAL;
-	adapter->tx_fc = ecmd->tx_pause;
-	adapter->rx_fc = ecmd->rx_pause;
 
-	status = be_cmd_set_flow_control(adapter,
-					 adapter->tx_fc, adapter->rx_fc);
-	if (status)
+	status = be_cmd_set_flow_control(adapter, ecmd->tx_pause,
+					 ecmd->rx_pause);
+	if (status) {
 		dev_warn(&adapter->pdev->dev, "Pause param set failed\n");
+		return be_cmd_status(status);
+	}
 
-	return be_cmd_status(status);
+	adapter->tx_fc = ecmd->tx_pause;
+	adapter->rx_fc = ecmd->rx_pause;
+	return 0;
 }
 
 static int be_set_phys_id(struct net_device *netdev,

drivers/net/ethernet/emulex/benet/be_main.c

@@ -3667,7 +3667,6 @@ int be_update_queues(struct be_adapter *adapter)
 static int be_setup(struct be_adapter *adapter)
 {
 	struct device *dev = &adapter->pdev->dev;
-	u32 tx_fc, rx_fc;
 	int status;
 
 	be_setup_init(adapter);
@@ -3717,11 +3716,14 @@ static int be_setup(struct be_adapter *adapter)
 
 	be_cmd_get_acpi_wol_cap(adapter);
 
-	be_cmd_get_flow_control(adapter, &tx_fc, &rx_fc);
+	status = be_cmd_set_flow_control(adapter, adapter->tx_fc,
+					 adapter->rx_fc);
+	if (status)
+		be_cmd_get_flow_control(adapter, &adapter->tx_fc,
+					&adapter->rx_fc);
 
-	if (rx_fc != adapter->rx_fc || tx_fc != adapter->tx_fc)
-		be_cmd_set_flow_control(adapter, adapter->tx_fc,
-					adapter->rx_fc);
+	dev_info(&adapter->pdev->dev, "HW Flow control - TX:%d RX:%d\n",
+		 adapter->tx_fc, adapter->rx_fc);
 
 	if (be_physfn(adapter))
 		be_cmd_set_logical_link_config(adapter,