spi: dw: Add DMA address widths capability check

Store address width capabilities of DMA controller during init and check
the same per transfer to make sure the bits/word requirement can be met.

Current DW DMA driver requires both tx and rx channel to be configured
and functional hence a subset of both tx and rx channel address width
capability is checked with the width requirement(n_bytes) for a
transfer.

* tested on Baikal-T1 based system with DW SPI-looped back interface
transferring a chunk of data with DFS:8,12,16.

Signed-off-by: Joy Chakraborty <joychakr@google.com
Reviewed-by: Serge Semin <fancer.lancer@gmail.com
Tested-by: Serge Semin <fancer.lancer@gmail.com
Link: https://lore.kernel.org/r/20230512104746.1797865-3-joychakr@google.com
Signed-off-by: Mark Brown <broonie@kernel.org

drivers/spi/spi-dw-dma.c

@@ -98,6 +98,13 @@ static int dw_spi_dma_caps_init(struct dw_spi *dws)
 	else
 		dws->dma_sg_burst = 0;
 
+	/*
+	 * Assuming both channels belong to the same DMA controller hence the
+	 * peripheral side address width capabilities most likely would be
+	 * the same.
+	 */
+	dws->dma_addr_widths = tx.dst_addr_widths & rx.src_addr_widths;
+
 	return 0;
 }
 
@@ -239,8 +246,14 @@ static bool dw_spi_can_dma(struct spi_controller *master,
 			   struct spi_device *spi, struct spi_transfer *xfer)
 {
 	struct dw_spi *dws = spi_controller_get_devdata(master);
+	enum dma_slave_buswidth dma_bus_width;
+
+	if (xfer->len <= dws->fifo_len)
+		return false;
+
+	dma_bus_width = dw_spi_dma_convert_width(dws->n_bytes);
 
-	return xfer->len > dws->fifo_len;
+	return dws->dma_addr_widths & BIT(dma_bus_width);
 }
 
 static int dw_spi_dma_wait(struct dw_spi *dws, unsigned int len, u32 speed)

drivers/spi/spi-dw.h

@@ -190,6 +190,7 @@ struct dw_spi {
 	struct dma_chan		*rxchan;
 	u32			rxburst;
 	u32			dma_sg_burst;
+	u32			dma_addr_widths;
 	unsigned long		dma_chan_busy;
 	dma_addr_t		dma_addr; /* phy address of the Data register */
 	const struct dw_spi_dma_ops *dma_ops;