amd: lance: use eth_hw_addr_set()

IO reads, so save to an array then eth_hw_addr_set().

Fixes build on x86 (32bit).
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/amd/lance.c

@@ -480,6 +480,7 @@ static int __init lance_probe1(struct net_device *dev, int ioaddr, int irq, int
 	unsigned long flags;
 	int err = -ENOMEM;
 	void __iomem *bios;
+	u8 addr[ETH_ALEN];
 
 	/* First we look for special cases.
 	   Check for HP's on-board ethernet by looking for 'HP' in the BIOS.
@@ -541,7 +542,8 @@ static int __init lance_probe1(struct net_device *dev, int ioaddr, int irq, int
 	/* There is a 16 byte station address PROM at the base address.
 	   The first six bytes are the station address. */
 	for (i = 0; i < 6; i++)
-		dev->dev_addr[i] = inb(ioaddr + i);
+		addr[i] = inb(ioaddr + i);
+	eth_hw_addr_set(dev, addr);
 	printk("%pM", dev->dev_addr);
 
 	dev->base_addr = ioaddr;