scsi: lpfc: Remove lpfc_enable_pbde as module parameter

Enablement of the PBDE optimization brought out some incompatible behaviors
under error scenarios.

Best to disable and remove the PBDE optimization.
Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <james.smart@broadcom.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/lpfc/lpfc_attr.c

@@ -5387,14 +5387,6 @@ LPFC_BBCR_ATTR_RW(enable_bbcr, 1, 0, 1, "Enable BBC Recovery");
  */
 LPFC_ATTR_RW(enable_dpp, 1, 0, 1, "Enable Direct Packet Push");
 
-/*
- * lpfc_enable_pbde: Enable PBDE on PRISM - G7
- *       0  = PBDE on G7 disabled
- *       1  = PBDE on G7 enabled (default)
- * Value range is [0,1]. Default value is 1
- */
-LPFC_ATTR_R(enable_pbde, 1, 0, 1, "Enable PBDE support on PRISM");
-
 struct device_attribute *lpfc_hba_attrs[] = {
 	&dev_attr_nvme_info,
 	&dev_attr_bg_info,
@@ -5506,7 +5498,6 @@ struct device_attribute *lpfc_hba_attrs[] = {
 	&dev_attr_lpfc_enable_mds_diags,
 	&dev_attr_lpfc_enable_bbcr,
 	&dev_attr_lpfc_enable_dpp,
-	&dev_attr_lpfc_enable_pbde,
 	NULL,
 };
 
@@ -6541,7 +6532,6 @@ lpfc_get_cfgparam(struct lpfc_hba *phba)
 	lpfc_nvme_io_channel_init(phba, lpfc_nvme_io_channel);
 	lpfc_enable_bbcr_init(phba, lpfc_enable_bbcr);
 	lpfc_enable_dpp_init(phba, lpfc_enable_dpp);
-	lpfc_enable_pbde_init(phba, lpfc_enable_pbde);
 
 	if (phba->sli_rev != LPFC_SLI_REV4) {
 		/* NVME only supported on SLI4 */
@@ -6558,6 +6548,8 @@ lpfc_get_cfgparam(struct lpfc_hba *phba)
 		phba->cfg_auto_imax = 0;
 	phba->initial_imax = phba->cfg_fcp_imax;
 
+	phba->cfg_enable_pbde = 0;
+
 	/* A value of 0 means use the number of CPUs found in the system */
 	if (phba->cfg_fcp_io_channel == 0)
 		phba->cfg_fcp_io_channel = phba->sli4_hba.num_present_cpu;