[ide] kill IDEPCI_FLAG_FORCE_MASTER

cs5530 overrides hwif->autodma anyway.
Signed-off-by: default avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent 062a3261
...@@ -353,7 +353,6 @@ static ide_pci_device_t cs5530_chipset __devinitdata = { ...@@ -353,7 +353,6 @@ static ide_pci_device_t cs5530_chipset __devinitdata = {
.channels = 2, .channels = 2,
.autodma = AUTODMA, .autodma = AUTODMA,
.bootable = ON_BOARD, .bootable = ON_BOARD,
.flags = IDEPCI_FLAG_FORCE_MASTER,
}; };
static int __devinit cs5530_init_one(struct pci_dev *dev, const struct pci_device_id *id) static int __devinit cs5530_init_one(struct pci_dev *dev, const struct pci_device_id *id)
......
...@@ -473,13 +473,8 @@ static void ide_hwif_setup_dma(struct pci_dev *dev, ide_pci_device_t *d, ide_hwi ...@@ -473,13 +473,8 @@ static void ide_hwif_setup_dma(struct pci_dev *dev, ide_pci_device_t *d, ide_hwi
* Set up BM-DMA capability * Set up BM-DMA capability
* (PnP BIOS should have done this) * (PnP BIOS should have done this)
*/ */
if ((d->flags & IDEPCI_FLAG_FORCE_MASTER) == 0) { /* default DMA off if we had to configure it here */
/* hwif->autodma = 0;
* default DMA off if we had to
* configure it here
*/
hwif->autodma = 0;
}
pci_set_master(dev); pci_set_master(dev);
if (pci_read_config_word(dev, PCI_COMMAND, &pcicmd) || !(pcicmd & PCI_COMMAND_MASTER)) { if (pci_read_config_word(dev, PCI_COMMAND, &pcicmd) || !(pcicmd & PCI_COMMAND_MASTER)) {
printk(KERN_ERR "%s: %s error updating PCICMD\n", printk(KERN_ERR "%s: %s error updating PCICMD\n",
......
...@@ -1453,9 +1453,7 @@ typedef struct ide_pci_enablebit_s { ...@@ -1453,9 +1453,7 @@ typedef struct ide_pci_enablebit_s {
enum { enum {
/* Uses ISA control ports not PCI ones. */ /* Uses ISA control ports not PCI ones. */
IDEPCI_FLAG_ISA_PORTS = (1 << 0), IDEPCI_FLAG_ISA_PORTS = (1 << 0),
IDEPCI_FLAG_FORCE_PDC = (1 << 1),
IDEPCI_FLAG_FORCE_MASTER = (1 << 1),
IDEPCI_FLAG_FORCE_PDC = (1 << 2),
}; };
typedef struct ide_pci_device_s { typedef struct ide_pci_device_s {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment