Revert "serial-uartlite: Add runtime support"

This reverts commit 0379b116.

As Johan says, this driver needs a lot more work and these changes are
only going in the wrong direction:
    https://lkml.kernel.org/r/20190523091839.GC568@localhostReported-by: Johan Hovold <johan@kernel.org>
Cc: Shubhrajyoti Datta <shubhrajyoti.datta@xilinx.com>
Cc: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/uartlite.c

@@ -22,7 +22,6 @@
 #include <linux/of_device.h>
 #include <linux/of_platform.h>
 #include <linux/clk.h>
-#include <linux/pm_runtime.h>
 
 #define ULITE_NAME		"ttyUL"
 #define ULITE_MAJOR		204
@@ -55,7 +54,6 @@
 #define ULITE_CONTROL_RST_TX	0x01
 #define ULITE_CONTROL_RST_RX	0x02
 #define ULITE_CONTROL_IE	0x10
-#define UART_AUTOSUSPEND_TIMEOUT	3000
 
 /* Static pointer to console port */
 #ifdef CONFIG_SERIAL_UARTLITE_CONSOLE
@@ -393,12 +391,12 @@ static int ulite_verify_port(struct uart_port *port, struct serial_struct *ser)
 static void ulite_pm(struct uart_port *port, unsigned int state,
 		     unsigned int oldstate)
 {
-	if (!state) {
-		pm_runtime_get_sync(port->dev);
-	} else {
-		pm_runtime_mark_last_busy(port->dev);
-		pm_runtime_put_autosuspend(port->dev);
-	}
+	struct uartlite_data *pdata = port->private_data;
+
+	if (!state)
+		clk_enable(pdata->clk);
+	else
+		clk_disable(pdata->clk);
 }
 
 #ifdef CONFIG_CONSOLE_POLL
@@ -745,32 +743,11 @@ static int __maybe_unused ulite_resume(struct device *dev)
 	return 0;
 }
 
-static int __maybe_unused ulite_runtime_suspend(struct device *dev)
-{
-	struct uart_port *port = dev_get_drvdata(dev);
-	struct uartlite_data *pdata = port->private_data;
-
-	clk_disable(pdata->clk);
-	return 0;
-};
-
-static int __maybe_unused ulite_runtime_resume(struct device *dev)
-{
-	struct uart_port *port = dev_get_drvdata(dev);
-	struct uartlite_data *pdata = port->private_data;
-
-	clk_enable(pdata->clk);
-	return 0;
-}
 /* ---------------------------------------------------------------------
  * Platform bus binding
  */
 
-static const struct dev_pm_ops ulite_pm_ops = {
-	SET_SYSTEM_SLEEP_PM_OPS(ulite_suspend, ulite_resume)
-	SET_RUNTIME_PM_OPS(ulite_runtime_suspend,
-			   ulite_runtime_resume, NULL)
-};
+static SIMPLE_DEV_PM_OPS(ulite_pm_ops, ulite_suspend, ulite_resume);
 
 #if defined(CONFIG_OF)
 /* Match table for of_platform binding */
@@ -843,15 +820,9 @@ static int ulite_probe(struct platform_device *pdev)
 		return ret;
 	}
 
-	pm_runtime_use_autosuspend(&pdev->dev);
-	pm_runtime_set_autosuspend_delay(&pdev->dev, UART_AUTOSUSPEND_TIMEOUT);
-	pm_runtime_set_active(&pdev->dev);
-	pm_runtime_enable(&pdev->dev);
-
 	ret = ulite_assign(&pdev->dev, id, res->start, irq, pdata);
 
-	pm_runtime_mark_last_busy(&pdev->dev);
-	pm_runtime_put_autosuspend(&pdev->dev);
+	clk_disable(pdata->clk);
 
 	return ret;
 }
@@ -860,14 +831,9 @@ static int ulite_remove(struct platform_device *pdev)
 {
 	struct uart_port *port = dev_get_drvdata(&pdev->dev);
 	struct uartlite_data *pdata = port->private_data;
-	int rc;
 
 	clk_disable_unprepare(pdata->clk);
-	rc = ulite_release(&pdev->dev);
-	pm_runtime_disable(&pdev->dev);
-	pm_runtime_set_suspended(&pdev->dev);
-	pm_runtime_dont_use_autosuspend(&pdev->dev);
-	return rc;
+	return ulite_release(&pdev->dev);
 }
 
 /* work with hotplug and coldplug */