Commit 08ed48e1 authored by Emil Tantilov's avatar Emil Tantilov Committed by Jeff Kirsher

ixgbe: always call setup_mac_link for multispeed fiber

Remove the logic which would previously skip the link configuration
in the case where we are already at the requested speed in
ixgbe_setup_mac_link_multispeed_fiber().

By exiting early we are skipping the link configuration and as such
the driver may not always configure the PHY correctly for SFP+.
Signed-off-by: default avatarEmil Tantilov <emil.s.tantilov@intel.com>
Tested-by: default avatarAndrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
parent 410a4949
...@@ -4121,15 +4121,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw, ...@@ -4121,15 +4121,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw,
speedcnt++; speedcnt++;
highest_link_speed = IXGBE_LINK_SPEED_10GB_FULL; highest_link_speed = IXGBE_LINK_SPEED_10GB_FULL;
/* If we already have link at this speed, just jump out */
status = hw->mac.ops.check_link(hw, &link_speed, &link_up,
false);
if (status)
return status;
if (link_speed == IXGBE_LINK_SPEED_10GB_FULL && link_up)
goto out;
/* Set the module link speed */ /* Set the module link speed */
switch (hw->phy.media_type) { switch (hw->phy.media_type) {
case ixgbe_media_type_fiber: case ixgbe_media_type_fiber:
...@@ -4181,15 +4172,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw, ...@@ -4181,15 +4172,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw,
if (highest_link_speed == IXGBE_LINK_SPEED_UNKNOWN) if (highest_link_speed == IXGBE_LINK_SPEED_UNKNOWN)
highest_link_speed = IXGBE_LINK_SPEED_1GB_FULL; highest_link_speed = IXGBE_LINK_SPEED_1GB_FULL;
/* If we already have link at this speed, just jump out */
status = hw->mac.ops.check_link(hw, &link_speed, &link_up,
false);
if (status)
return status;
if (link_speed == IXGBE_LINK_SPEED_1GB_FULL && link_up)
goto out;
/* Set the module link speed */ /* Set the module link speed */
switch (hw->phy.media_type) { switch (hw->phy.media_type) {
case ixgbe_media_type_fiber: case ixgbe_media_type_fiber:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment