ARM: dts: ARM: dts: Fix omap5 SDIO dat1 interrupt

Few changes to fix issues I've noticed while debugging omap5-uevm
wl18xx issues:

1. Move wlcore irq pin muxing under wlcore. This irq could be
   different from gpio_wk14 on some board variants

2. Don't configure pull on wlcore irq pin. There is a 10k
   pull up resistor R105 on the device to VDDS_1v8_MAIN

3. The padconf register for wlsdio_data1 is wrong, it's really
   at 0x1a8 + 2 - 0x40 = 0x16a offset, not at 0x168 as that's
   for wlsdio_data0

4. Mark the omap5-uevm wlan as compatible with ti,wl1837 as
   that's what the TDK R078 part seems to be

5. The MMC interrupt for WLAN musb be wakeupgen, not gic

Looks like omap5-uevm WLAN behaves better now, but I still seem
to have issues with some access points.
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/boot/dts/omap5-board-common.dtsi

@@ -332,7 +332,7 @@ OMAP5_IOPAD(0x05a, PIN_OUTPUT | MUX_MODE0) /* fref_clk1_out, USB hub clk */
 
 	wlcore_irq_pin: pinmux_wlcore_irq_pin {
 		pinctrl-single,pins = <
-			OMAP5_IOPAD(0x40, PIN_INPUT_PULLUP | MUX_MODE6)	/* llia_wakereqin.gpio1_wk14 */
+			OMAP5_IOPAD(0x40, PIN_INPUT | MUX_MODE6)	/* llia_wakereqin.gpio1_wk14 */
 		>;
 	};
 };
@@ -355,15 +355,17 @@ &mmc3 {
 	non-removable;
 	cap-power-off-card;
 	pinctrl-names = "default";
-	pinctrl-0 = <&mmc3_pins &wlcore_irq_pin>;
-	interrupts-extended = <&gic GIC_SPI 94 IRQ_TYPE_LEVEL_HIGH
-			       &omap5_pmx_core 0x168>;
+	pinctrl-0 = <&mmc3_pins>;
+	interrupts-extended = <&wakeupgen GIC_SPI 94 IRQ_TYPE_LEVEL_HIGH
+			       &omap5_pmx_core 0x16a>;
 
 	#address-cells = <1>;
 	#size-cells = <0>;
 	wlcore: wlcore@2 {
 		compatible = "ti,wl1271";
 		reg = <2>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&wlcore_irq_pin>;
 		interrupt-parent = <&gpio1>;
 		interrupts = <14 IRQ_TYPE_LEVEL_HIGH>;	/* gpio 14 */
 		ref-clock-frequency = <26000000>;

arch/arm/boot/dts/omap5-uevm.dts

@@ -61,3 +61,7 @@ &twl6040_pins {
 		OMAP5_IOPAD(0x1be, PIN_OUTPUT | MUX_MODE6)	/* mcspi1_somi.gpio5_141 */
 	>;
 };
+
+&wlcore {
+	compatible = "ti,wl1837";
+};