WAN: farsync driver no longer uses syncppp.c directly

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

drivers/net/wan/Makefile

@@ -24,7 +24,7 @@ pc300-objs			:= $(pc300-y)
 obj-$(CONFIG_HOSTESS_SV11)	+= z85230.o	syncppp.o	hostess_sv11.o
 obj-$(CONFIG_SEALEVEL_4021)	+= z85230.o	syncppp.o	sealevel.o
 obj-$(CONFIG_COSA)		+=		syncppp.o	cosa.o
-obj-$(CONFIG_FARSYNC)		+=		syncppp.o	farsync.o
+obj-$(CONFIG_FARSYNC)		+= farsync.o
 obj-$(CONFIG_DSCC4)             +=				dscc4.o
 obj-$(CONFIG_LANMEDIA)		+=		syncppp.o
 obj-$(CONFIG_X25_ASY)		+= x25_asy.o

drivers/net/wan/farsync.c

@@ -47,10 +47,7 @@ MODULE_LICENSE("GPL");
 /*      Default parameters for the link
  */
 #define FST_TX_QUEUE_LEN        100	/* At 8Mbps a longer queue length is
-					 * useful, the syncppp module forces
-					 * this down assuming a slower line I
-					 * guess.
-					 */
+					 * useful */
 #define FST_TXQ_DEPTH           16	/* This one is for the buffering
 					 * of frames on the way down to the card
 					 * so that we can keep the card busy

drivers/net/wan/farsync.h

@@ -54,9 +54,6 @@
 
 
 /*      Ioctl call command values
- *
- *      The first three private ioctls are used by the sync-PPP module,
- *      allowing a little room for expansion we start our numbering at 10.
  */
 #define FSTWRITE        (SIOCDEVPRIVATE+10)
 #define FSTCPURESET     (SIOCDEVPRIVATE+11)
@@ -202,9 +199,6 @@ struct fstioc_info {
 #define J1              7
 
 /* "proto" */
-#define FST_HDLC        1               /* Cisco compatible HDLC */
-#define FST_PPP         2               /* Sync PPP */
-#define FST_MONITOR     3               /* Monitor only (raw packet reception) */
 #define FST_RAW         4               /* Two way raw packets */
 #define FST_GEN_HDLC    5               /* Using "Generic HDLC" module */