Commit 0cb38d65 authored by Wey-Yi Guy's avatar Wey-Yi Guy

iwlwifi: P2P is not enabled by default

P2P still under development. it will not enabled by default, but user
always can enable it manually for testing.
Signed-off-by: default avatarWey-Yi Guy <wey-yi.w.guy@intel.com>
parent 0bec12b8
...@@ -111,3 +111,19 @@ config IWLWIFI_DEVICE_TESTMODE ...@@ -111,3 +111,19 @@ config IWLWIFI_DEVICE_TESTMODE
NL80211_TESTMODE. This provide the capabilities of enable user space NL80211_TESTMODE. This provide the capabilities of enable user space
validation applications to interacts with the device through the validation applications to interacts with the device through the
generic netlink message via NL80211_TESTMODE channel. generic netlink message via NL80211_TESTMODE channel.
config IWLWIFI_P2P
bool "iwlwifi experimental P2P support"
depends on IWLWIFI
help
This option enables experimental P2P support for some devices
based on microcode support. Since P2P support is still under
development, this option may even enable it for some devices
now that turn out to not support it in the future due to
microcode restrictions.
To determine if your microcode supports the experimental P2P
offered by this option, check if the driver advertises AP
support when it is loaded.
Say Y only if you want to experiment with P2P.
...@@ -1036,6 +1036,9 @@ static void iwl_ucode_callback(const struct firmware *ucode_raw, void *context) ...@@ -1036,6 +1036,9 @@ static void iwl_ucode_callback(const struct firmware *ucode_raw, void *context)
priv->inst_evtlog_size = priv->inst_evtlog_size =
priv->cfg->base_params->max_event_log_size; priv->cfg->base_params->max_event_log_size;
priv->inst_errlog_ptr = pieces.inst_errlog_ptr; priv->inst_errlog_ptr = pieces.inst_errlog_ptr;
#ifndef CONFIG_IWLWIFI_P2P
ucode_capa.flags &= ~IWL_UCODE_TLV_FLAGS_PAN;
#endif
priv->new_scan_threshold_behaviour = priv->new_scan_threshold_behaviour =
!!(ucode_capa.flags & IWL_UCODE_TLV_FLAGS_NEWSCAN); !!(ucode_capa.flags & IWL_UCODE_TLV_FLAGS_NEWSCAN);
...@@ -1057,7 +1060,6 @@ static void iwl_ucode_callback(const struct firmware *ucode_raw, void *context) ...@@ -1057,7 +1060,6 @@ static void iwl_ucode_callback(const struct firmware *ucode_raw, void *context)
priv->sta_key_max_num = STA_KEY_MAX_NUM; priv->sta_key_max_num = STA_KEY_MAX_NUM;
priv->shrd->cmd_queue = IWL_DEFAULT_CMD_QUEUE_NUM; priv->shrd->cmd_queue = IWL_DEFAULT_CMD_QUEUE_NUM;
} }
/* /*
* figure out the offset of chain noise reset and gain commands * figure out the offset of chain noise reset and gain commands
* base on the size of standard phy calibration commands table size * base on the size of standard phy calibration commands table size
...@@ -1708,6 +1710,12 @@ static void iwl_debug_config(struct iwl_priv *priv) ...@@ -1708,6 +1710,12 @@ static void iwl_debug_config(struct iwl_priv *priv)
"enabled\n"); "enabled\n");
#else #else
"disabled\n"); "disabled\n");
#endif
dev_printk(KERN_INFO, bus(priv)->dev, "CONFIG_IWLWIFI_P2P "
#ifdef CONFIG_IWLWIFI_P2P
"enabled\n");
#else
"disabled\n");
#endif #endif
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment