ARM: OMAP1: ams-delta: Drop unused symbols from the board header

Those bitmap symbols defining pins of latch2 register, used with
read()/write() calls before the latch was converted to a GPIO device,
have been obsoleted by integer symbols defined inside the board file.
Signed-off-by: Janusz Krzysztofik <jmkrzyszt@gmail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap1/board-ams-delta.h

@@ -28,10 +28,6 @@
 
 #if defined (CONFIG_MACH_AMS_DELTA)
 
-#define AMD_DELTA_LATCH2_SCARD_RSTIN	0x0400
-#define AMD_DELTA_LATCH2_SCARD_CMDVCC	0x0800
-#define AMS_DELTA_LATCH2_MODEM_CODEC	0x2000
-
 #define AMS_DELTA_GPIO_PIN_KEYBRD_DATA	0
 #define AMS_DELTA_GPIO_PIN_KEYBRD_CLK	1
 #define AMS_DELTA_GPIO_PIN_MODEM_IRQ	2