USB: OHCI: Properly handle ohci-s3c2410 suspend

Suspend scenario in case of ohci-s3c2410 glue was not
properly handled as it was not suspending generic part
of ohci controller. Alan Stern suggested, properly handle
ohci-s3c2410 suspend scenario.

Calling explicitly the ohci_suspend()
routine in ohci_hcd_s3c2410_drv_suspend() will ensure
proper handling of suspend scenario.
Signed-off-by: Manjunath Goudar <csmanjuvijay@gmail.com>
Acked-by: Alan Stern <stern@rowland.harvard.edu>
Cc: Ben Dooks <ben-linux@fluff.org>
Cc: Kukjin Kim <kgene.kim@samsung.com>
Cc: linux-arm-kernel@lists.infradead.org
Cc: linux-samsung-soc@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Cc: linux-usb@vger.kernel.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/host/ohci-s3c2410.c

@@ -426,28 +426,15 @@ static int ohci_hcd_s3c2410_drv_remove(struct platform_device *pdev)
 static int ohci_hcd_s3c2410_drv_suspend(struct device *dev)
 {
 	struct usb_hcd *hcd = dev_get_drvdata(dev);
-	struct ohci_hcd *ohci = hcd_to_ohci(hcd);
 	struct platform_device *pdev = to_platform_device(dev);
-	unsigned long flags;
+	bool do_wakeup = device_may_wakeup(dev);
 	int rc = 0;
 
-	/*
-	 * Root hub was already suspended. Disable irq emission and
-	 * mark HW unaccessible, bail out if RH has been resumed. Use
-	 * the spinlock to properly synchronize with possible pending
-	 * RH suspend or resume activity.
-	 */
-	spin_lock_irqsave(&ohci->lock, flags);
-	if (ohci->rh_state != OHCI_RH_SUSPENDED) {
-		rc = -EINVAL;
-		goto bail;
-	}
-
-	clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
+	rc = ohci_suspend(hcd, do_wakeup);
+	if (rc)
+		return rc;
 
 	s3c2410_stop_hc(pdev);
-bail:
-	spin_unlock_irqrestore(&ohci->lock, flags);
 
 	return rc;
 }