Commit 0ed50abb authored by Daniel Glöckner's avatar Daniel Glöckner Committed by Ulf Hansson

mmc: block: don't use CMD23 with very old MMC cards

CMD23 aka SET_BLOCK_COUNT was introduced with MMC v3.1.
Older versions of the specification allowed to terminate
multi-block transfers only with CMD12.

The patch fixes the following problem:

  mmc0: new MMC card at address 0001
  mmcblk0: mmc0:0001 SDMB-16 15.3 MiB
  mmcblk0: timed out sending SET_BLOCK_COUNT command, card status 0x400900
  ...
  blk_update_request: I/O error, dev mmcblk0, sector 0
  Buffer I/O error on dev mmcblk0, logical block 0, async page read
   mmcblk0: unable to read partition table
Signed-off-by: default avatarDaniel Glöckner <dg@emlix.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent 92add82e
......@@ -2303,7 +2303,8 @@ static struct mmc_blk_data *mmc_blk_alloc_req(struct mmc_card *card,
set_capacity(md->disk, size);
if (mmc_host_cmd23(card->host)) {
if (mmc_card_mmc(card) ||
if ((mmc_card_mmc(card) &&
card->csd.mmca_vsn >= CSD_SPEC_VER_3) ||
(mmc_card_sd(card) &&
card->scr.cmds & SD_SCR_CMD23_SUPPORT))
md->flags |= MMC_BLK_CMD23;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment