usb: typec: intel_pmc_mux: Configure HPD first for HPD+IRQ request

Warm reboot scenarios some times type C Mux driver gets Mux configuration
request as HPD=1,IRQ=1. In that scenario typeC Mux driver need to configure
Mux as follows as per IOM requirement:
 (1). Confgiure Mux HPD = 1, IRQ = 0
 (2). Configure Mux with HPD = 1, IRQ = 1

IOM expects TypeC Mux configuration as follows:
 (1). HPD=1, IRQ=0
 (2). HPD=1, IRQ=1
if IOM gets mux config request (2) without configuring (1), it will ignore
the request. The impact of this is there is no DP_alt mode display.

Fixes: 43d596e3 ("usb: typec: intel_pmc_mux: Check the port status before connect")
Cc: stable@vger.kernel.org
Reviewed-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Madhusudanarao Amara <madhusudanarao.amara@intel.com>
Link: https://lore.kernel.org/r/20201216140918.49197-1-madhusudanarao.amara@intel.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/typec/mux/intel_pmc_mux.c

@@ -207,10 +207,21 @@ static int
 pmc_usb_mux_dp_hpd(struct pmc_usb_port *port, struct typec_displayport_data *dp)
 {
 	u8 msg[2] = { };
+	int ret;
 
 	msg[0] = PMC_USB_DP_HPD;
 	msg[0] |= port->usb3_port << PMC_USB_MSG_USB3_PORT_SHIFT;
 
+	/* Configure HPD first if HPD,IRQ comes together */
+	if (!IOM_PORT_HPD_ASSERTED(port->iom_status) &&
+	    dp->status & DP_STATUS_IRQ_HPD &&
+	    dp->status & DP_STATUS_HPD_STATE) {
+		msg[1] = PMC_USB_DP_HPD_LVL;
+		ret = pmc_usb_command(port, msg, sizeof(msg));
+		if (ret)
+			return ret;
+	}
+
 	if (dp->status & DP_STATUS_IRQ_HPD)
 		msg[1] = PMC_USB_DP_HPD_IRQ;