net: amd: remove leading spaces before tabs

There are a few leading spaces before tabs and remove it by running the
following commard:

	$ find . -name '*.c' | xargs sed -r -i 's/^[ ]+\t/\t/'
	$ find . -name '*.h' | xargs sed -r -i 's/^[ ]+\t/\t/'
Signed-off-by: Hui Tang <tanghui20@huawei.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/amd/amd8111e.c

@@ -19,14 +19,14 @@ Module Name:
 
 Abstract:
 
- 	 AMD8111 based 10/100 Ethernet Controller Driver.
+	 AMD8111 based 10/100 Ethernet Controller Driver.
 
 Environment:
 
 	Kernel Mode
 
 Revision History:
- 	3.0.0
+	3.0.0
 	   Initial Revision.
 	3.0.1
 	 1. Dynamic interrupt coalescing.

drivers/net/ethernet/amd/amd8111e.h

@@ -10,14 +10,14 @@ Module Name:
 
 Abstract:
 
- 	 AMD8111 based 10/100 Ethernet Controller driver definitions.
+	 AMD8111 based 10/100 Ethernet Controller driver definitions.
 
 Environment:
 
 	Kernel Mode
 
 Revision History:
- 	3.0.0
+	3.0.0
 	   Initial Revision.
 	3.0.1
 */
@@ -692,7 +692,7 @@ enum coal_type{
 };
 
 enum coal_mode{
-       	RX_INTR_COAL,
+	RX_INTR_COAL,
 	TX_INTR_COAL,
 	DISABLE_COAL,
 	ENABLE_COAL,

drivers/net/ethernet/amd/atarilance.c

@@ -706,7 +706,7 @@ static void lance_init_ring( struct net_device *dev )
 		CHECK_OFFSET(offset);
 		MEM->tx_head[i].base = offset;
 		MEM->tx_head[i].flag = TMD1_OWN_HOST;
- 		MEM->tx_head[i].base_hi = 0;
+		MEM->tx_head[i].base_hi = 0;
 		MEM->tx_head[i].length = 0;
 		MEM->tx_head[i].misc = 0;
 		offset += PKT_BUF_SZ;

drivers/net/ethernet/amd/declance.c

@@ -937,7 +937,7 @@ static netdev_tx_t lance_start_xmit(struct sk_buff *skb, struct net_device *dev)
 
 	dev_kfree_skb(skb);
 
- 	return NETDEV_TX_OK;
+	return NETDEV_TX_OK;
 }
 
 static void lance_load_multicast(struct net_device *dev)

drivers/net/ethernet/amd/lance.c

@@ -780,7 +780,7 @@ lance_open(struct net_device *dev)
 		outw(0x0002, ioaddr+LANCE_ADDR);
 		/* Only touch autoselect bit. */
 		outw(inw(ioaddr+LANCE_BUS_IF) | 0x0002, ioaddr+LANCE_BUS_IF);
- 	}
+	}
 
 	if (lance_debug > 1)
 		printk("%s: lance_open() irq %d dma %d tx/rx rings %#x/%#x init %#x.\n",
@@ -812,7 +812,7 @@ lance_open(struct net_device *dev)
 	 * We used to clear the InitDone bit, 0x0100, here but Mark Stockton
 	 * reports that doing so triggers a bug in the '974.
 	 */
- 	outw(0x0042, ioaddr+LANCE_DATA);
+	outw(0x0042, ioaddr+LANCE_DATA);
 
 	if (lance_debug > 2)
 		printk("%s: LANCE open after %d ticks, init block %#x csr0 %4.4x.\n",

drivers/net/ethernet/amd/ni65.c

@@ -193,7 +193,7 @@ static struct card {
 		.vendor_id   = ni_vendor,
 		.cardname    = "ni6510",
 		.config	     = 0x1,
-       	},
+	},
 	{
 		.id0	     = NI65_EB_ID0,
 		.id1	     = NI65_EB_ID1,
@@ -204,7 +204,7 @@ static struct card {
 		.vendor_id   = ni_vendor,
 		.cardname    = "ni6510 EtherBlaster",
 		.config	     = 0x2,
-       	},
+	},
 	{
 		.id0	     = NE2100_ID0,
 		.id1	     = NE2100_ID1,
@@ -1232,15 +1232,15 @@ MODULE_PARM_DESC(dma, "ni6510 ISA DMA channel (ignored for some cards)");
 
 int __init init_module(void)
 {
- 	dev_ni65 = ni65_probe(-1);
+	dev_ni65 = ni65_probe(-1);
 	return PTR_ERR_OR_ZERO(dev_ni65);
 }
 
 void __exit cleanup_module(void)
 {
- 	unregister_netdev(dev_ni65);
- 	cleanup_card(dev_ni65);
- 	free_netdev(dev_ni65);
+	unregister_netdev(dev_ni65);
+	cleanup_card(dev_ni65);
+	free_netdev(dev_ni65);
 }
 #endif /* MODULE */
 

drivers/net/ethernet/amd/nmclan_cs.c

@@ -541,7 +541,7 @@ static int mace_init(mace_private *lp, unsigned int ioaddr, char *enet_addr)
     if(++ct > 500)
     {
 	pr_err("reset failed, card removed?\n");
-    	return -1;
+	return -1;
     }
     udelay(1);
   }
@@ -585,11 +585,11 @@ static int mace_init(mace_private *lp, unsigned int ioaddr, char *enet_addr)
   ct = 0;
   while (mace_read(lp, ioaddr, MACE_IAC) & MACE_IAC_ADDRCHG)
   {
-  	if(++ ct > 500)
-  	{
+	if(++ ct > 500)
+	{
 		pr_err("ADDRCHG timeout, card removed?\n");
-  		return -1;
-  	}
+		return -1;
+	}
   }
   /* Set PADR register */
   for (i = 0; i < ETH_ALEN; i++)
@@ -655,7 +655,7 @@ static int nmclan_config(struct pcmcia_device *link)
   }
 
   if(mace_init(lp, ioaddr, dev->dev_addr) == -1)
-  	goto failed;
+	goto failed;
 
   /* The if_port symbol can be set when the module is loaded */
   if (if_port <= 2)

drivers/net/ethernet/amd/sun3lance.c

@@ -150,7 +150,7 @@ struct lance_memory {
 struct lance_private {
 	volatile unsigned short	*iobase;
 	struct lance_memory	*mem;
-     	int new_rx, new_tx;	/* The next free ring entry */
+	int new_rx, new_tx;	/* The next free ring entry */
 	int old_tx, old_rx;     /* ring entry to be processed */
 /* These two must be longs for set_bit() */
 	long	    tx_full;
@@ -465,7 +465,7 @@ static void lance_init_ring( struct net_device *dev )
 	for( i = 0; i < TX_RING_SIZE; i++ ) {
 		MEM->tx_head[i].base = dvma_vtob(MEM->tx_data[i]);
 		MEM->tx_head[i].flag = 0;
- 		MEM->tx_head[i].base_hi =
+		MEM->tx_head[i].base_hi =
 			(dvma_vtob(MEM->tx_data[i])) >>16;
 		MEM->tx_head[i].length = 0;
 		MEM->tx_head[i].misc = 0;
@@ -581,8 +581,8 @@ lance_start_xmit(struct sk_buff *skb, struct net_device *dev)
 	}
 
 	AREG = CSR0;
-  	DPRINTK( 2, ( "%s: lance_start_xmit() called, csr0 %4.4x.\n",
-  				  dev->name, DREG ));
+	DPRINTK( 2, ( "%s: lance_start_xmit() called, csr0 %4.4x.\n",
+				  dev->name, DREG ));
 
 #ifdef CONFIG_SUN3X
 	/* this weirdness doesn't appear on sun3... */
@@ -636,8 +636,8 @@ lance_start_xmit(struct sk_buff *skb, struct net_device *dev)
 	/* Trigger an immediate send poll. */
 	REGA(CSR0) = CSR0_INEA | CSR0_TDMD | CSR0_STRT;
 	AREG = CSR0;
-  	DPRINTK( 2, ( "%s: lance_start_xmit() exiting, csr0 %4.4x.\n",
-  				  dev->name, DREG ));
+	DPRINTK( 2, ( "%s: lance_start_xmit() exiting, csr0 %4.4x.\n",
+				  dev->name, DREG ));
 	dev_kfree_skb(skb);
 
 	lp->lock = 0;