Commit 11d509ad authored by Alexandru Ardelean's avatar Alexandru Ardelean Committed by Jonathan Cameron

staging:iio:ad2s90: Add max frequency check at probe

This patch adds a max frequency check at the beginning of ad2s90_probe
function so that when it is set to a value above 0.83Mhz, dev_err is
called with an appropriate message and -EINVAL is returned.

The defined limit is 0.83Mhz instead of 2Mhz, which is the chip's max
frequency as specified in the datasheet, because, as also specified in
the datasheet, a 600ns delay is expected between the application of a
logic LO to CS and the application of SCLK. Since the delay is not
implemented in the spi code, to satisfy it, SCLK's period should be at
most 2 * 600ns, so the max frequency should be 1 / (2 * 6e-7), which
gives roughly 830000Hz.
Signed-off-by: default avatarAlexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: default avatarMatheus Tavares <matheus.bernardino@usp.br>
Signed-off-by: default avatarJonathan Cameron <Jonathan.Cameron@huawei.com>
parent a996590b
......@@ -19,6 +19,12 @@
#include <linux/iio/iio.h>
#include <linux/iio/sysfs.h>
/*
* Although chip's max frequency is 2Mhz, it needs 600ns between CS and the
* first falling edge of SCLK, so frequency should be at most 1 / (2 * 6e-7)
*/
#define AD2S90_MAX_SPI_FREQ_HZ 830000
struct ad2s90_state {
struct mutex lock;
struct spi_device *sdev;
......@@ -78,6 +84,12 @@ static int ad2s90_probe(struct spi_device *spi)
struct iio_dev *indio_dev;
struct ad2s90_state *st;
if (spi->max_speed_hz > AD2S90_MAX_SPI_FREQ_HZ) {
dev_err(&spi->dev, "SPI CLK, %d Hz exceeds %d Hz\n",
spi->max_speed_hz, AD2S90_MAX_SPI_FREQ_HZ);
return -EINVAL;
}
indio_dev = devm_iio_device_alloc(&spi->dev, sizeof(*st));
if (!indio_dev)
return -ENOMEM;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment