Commit 12e4396b authored by Atsushi Nemoto's avatar Atsushi Nemoto Committed by Ralf Baechle

[MIPS] No need to write c0_compare in plat_timer_setup

If R4k counter was used for hpt_timer and interrupt source,
c0_hpt_timer_init() initializes the c0_compare register.
Signed-off-by: default avatarAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: default avatarRalf Baechle <ralf@linux-mips.org>
parent a0574e04
......@@ -116,7 +116,6 @@ static void lasat_time_init(void)
void __init plat_timer_setup(struct irqaction *irq)
{
write_c0_compare( read_c0_count() + mips_hpt_frequency / HZ);
change_c0_status(ST0_IM, IE_IRQ0 | IE_IRQ5);
}
......
......@@ -295,7 +295,4 @@ void __init plat_timer_setup(struct irqaction *irq)
irq_desc[mips_cpu_timer_irq].status |= IRQ_PER_CPU;
set_irq_handler(mips_cpu_timer_irq, handle_percpu_irq);
#endif
/* to generate the first timer interrupt */
write_c0_compare (read_c0_count() + mips_hpt_frequency/HZ);
}
......@@ -199,7 +199,4 @@ void __init plat_timer_setup(struct irqaction *irq)
irq_desc[mips_cpu_timer_irq].flags |= IRQ_PER_CPU;
set_irq_handler(mips_cpu_timer_irq, handle_percpu_irq);
#endif
/* to generate the first timer interrupt */
write_c0_compare(read_c0_count() + (mips_hpt_frequency/HZ));
}
......@@ -81,18 +81,8 @@ void __init tx4927_time_init(void)
void __init plat_timer_setup(struct irqaction *irq)
{
u32 count;
u32 c1;
u32 c2;
setup_irq(TX4927_IRQ_CPU_TIMER, irq);
/* to generate the first timer interrupt */
c1 = read_c0_count();
count = c1 + (mips_hpt_frequency / HZ);
write_c0_compare(count);
c2 = read_c0_count();
#ifdef CONFIG_TOSHIBA_RBTX4927
{
extern void toshiba_rbtx4927_timer_setup(struct irqaction
......
......@@ -55,14 +55,5 @@ tx4938_time_init(void)
void __init plat_timer_setup(struct irqaction *irq)
{
u32 count;
u32 c1;
u32 c2;
setup_irq(TX4938_IRQ_CPU_TIMER, irq);
c1 = read_c0_count();
count = c1 + (mips_hpt_frequency / HZ);
write_c0_compare(count);
c2 = read_c0_count();
}
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment