usb: typec: ucsi: acpi: Increase command completion timeout value

UCSI specification quite clearly states that if a command
can't be completed in 10ms, the firmware must notify
about BUSY condition. Unfortunately almost none of the
platforms (the firmware on them) generate the BUSY
notification even if a command can't be completed in time.

The driver already considered that, and used a timeout
value of 5 seconds, but processing especially the alternate
mode discovery commands takes often considerable amount of
time from the firmware, much more than the 5 seconds. That
happens especially after bootup when devices are already
connected to the USB Type-C connector. For now on those
platforms the alternate mode discovery has simply failed
because of the timeout.

To improve the situation, increasing the timeout value for
the command completion to 1 minute. That should give enough
time for even the slowest firmware to process the commands.

Fixes: f56de278 ("usb: typec: ucsi: acpi: Move to the new API")
Cc: stable@vger.kernel.org
Signed-off-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Link: https://lore.kernel.org/r/20200916090034.25119-2-heikki.krogerus@linux.intel.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/typec/ucsi/ucsi_acpi.c

@@ -78,7 +78,7 @@ static int ucsi_acpi_sync_write(struct ucsi *ucsi, unsigned int offset,
 	if (ret)
 		goto out_clear_bit;
 
-	if (!wait_for_completion_timeout(&ua->complete, msecs_to_jiffies(5000)))
+	if (!wait_for_completion_timeout(&ua->complete, 60 * HZ))
 		ret = -ETIMEDOUT;
 
 out_clear_bit: