Merge tag 'omap-for-v6.5/fixes-signed' of...

Merge tag 'omap-for-v6.5/fixes-signed' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into arm/fixes

Fixes for omaps

A fix external abort on non-linefetch for am335x that is fixed with a flush
of posted write. And two networking fixes for beaglebone mostly for revision
c3 to do phy reset with a gpio and to fix a boot time warning.

* tag 'omap-for-v6.5/fixes-signed' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap:
  ARM: dts: am335x-bone-common: Add vcc-supply for on-board eeprom
  ARM: dts: am335x-bone-common: Add GPIO PHY reset on revision C3 board
  bus: ti-sysc: Flush posted write on enable before reset

Link: https://lore.kernel.org/r/pull-1692158536-457318@atomide.comSigned-off-by: Arnd Bergmann <arnd@arndb.de>

arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi

@@ -145,6 +145,8 @@ davinci_mdio_default: davinci-mdio-default-pins {
 			/* MDIO */
 			AM33XX_PADCONF(AM335X_PIN_MDIO, PIN_INPUT_PULLUP | SLEWCTRL_FAST, MUX_MODE0)
 			AM33XX_PADCONF(AM335X_PIN_MDC, PIN_OUTPUT_PULLUP, MUX_MODE0)
+			/* Added to support GPIO controlled PHY reset */
+			AM33XX_PADCONF(AM335X_PIN_UART0_CTSN, PIN_OUTPUT_PULLUP, MUX_MODE7)
 		>;
 	};
 
@@ -153,6 +155,8 @@ davinci_mdio_sleep: davinci-mdio-sleep-pins {
 			/* MDIO reset value */
 			AM33XX_PADCONF(AM335X_PIN_MDIO, PIN_INPUT_PULLDOWN, MUX_MODE7)
 			AM33XX_PADCONF(AM335X_PIN_MDC, PIN_INPUT_PULLDOWN, MUX_MODE7)
+			/* Added to support GPIO controlled PHY reset */
+			AM33XX_PADCONF(AM335X_PIN_UART0_CTSN, PIN_INPUT_PULLDOWN, MUX_MODE7)
 		>;
 	};
 
@@ -215,6 +219,7 @@ tps: tps@24 {
 	baseboard_eeprom: baseboard_eeprom@50 {
 		compatible = "atmel,24c256";
 		reg = <0x50>;
+		vcc-supply = <&ldo4_reg>;
 
 		#address-cells = <1>;
 		#size-cells = <1>;
@@ -377,6 +382,10 @@ &davinci_mdio_sw {
 
 	ethphy0: ethernet-phy@0 {
 		reg = <0>;
+		/* Support GPIO reset on revision C3 boards */
+		reset-gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
+		reset-assert-us = <300>;
+		reset-deassert-us = <6500>;
 	};
 };
 

drivers/bus/ti-sysc.c

@@ -2142,6 +2142,8 @@ static int sysc_reset(struct sysc *ddata)
 		sysc_val = sysc_read_sysconfig(ddata);
 		sysc_val |= sysc_mask;
 		sysc_write(ddata, sysc_offset, sysc_val);
+		/* Flush posted write */
+		sysc_val = sysc_read_sysconfig(ddata);
 	}
 
 	if (ddata->cfg.srst_udelay)