Commit 188fa104 authored by Jakub Kicinski's avatar Jakub Kicinski

Merge branch '1GbE' of git://git.kernel.org/pub/scm/linux/kernel/git/tnguy/net-queue

Tony Nguyen says:

====================
Intel Wired LAN Driver Updates 2021-02-01

This series contains updates to igc and i40e drivers.

Kai-Heng Feng fixes igc to report unknown speed and duplex during suspend
as an attempted read will cause errors.

Kevin Lo sets the default value to -IGC_ERR_NVM instead of success for
writing shadow RAM as this could miss a timeout. Also propagates the return
value for Flow Control configuration to properly pass on errors for igc.

Aleksandr reverts commit 2ad1274f ("i40e: don't report link up for a VF
who hasn't enabled queues") as this can cause link flapping.

* '1GbE' of git://git.kernel.org/pub/scm/linux/kernel/git/tnguy/net-queue:
  i40e: Revert "i40e: don't report link up for a VF who hasn't enabled queues"
  igc: check return value of ret_val in igc_config_fc_after_link_up
  igc: set the default return value to -IGC_ERR_NVM in igc_write_nvm_srwr
  igc: Report speed and duplex as unknown when device is runtime suspended
====================

Link: https://lore.kernel.org/r/20210201214618.852831-1-anthony.l.nguyen@intel.comSigned-off-by: default avatarJakub Kicinski <kuba@kernel.org>
parents 31628201 f559a356
......@@ -55,12 +55,7 @@ static void i40e_vc_notify_vf_link_state(struct i40e_vf *vf)
pfe.event = VIRTCHNL_EVENT_LINK_CHANGE;
pfe.severity = PF_EVENT_SEVERITY_INFO;
/* Always report link is down if the VF queues aren't enabled */
if (!vf->queues_enabled) {
pfe.event_data.link_event.link_status = false;
pfe.event_data.link_event.link_speed = 0;
} else if (vf->link_forced) {
if (vf->link_forced) {
pfe.event_data.link_event.link_status = vf->link_up;
pfe.event_data.link_event.link_speed =
(vf->link_up ? i40e_virtchnl_link_speed(ls->link_speed) : 0);
......@@ -70,7 +65,6 @@ static void i40e_vc_notify_vf_link_state(struct i40e_vf *vf)
pfe.event_data.link_event.link_speed =
i40e_virtchnl_link_speed(ls->link_speed);
}
i40e_aq_send_msg_to_vf(hw, abs_vf_id, VIRTCHNL_OP_EVENT,
0, (u8 *)&pfe, sizeof(pfe), NULL);
}
......@@ -2443,8 +2437,6 @@ static int i40e_vc_enable_queues_msg(struct i40e_vf *vf, u8 *msg)
}
}
vf->queues_enabled = true;
error_param:
/* send the response to the VF */
return i40e_vc_send_resp_to_vf(vf, VIRTCHNL_OP_ENABLE_QUEUES,
......@@ -2466,9 +2458,6 @@ static int i40e_vc_disable_queues_msg(struct i40e_vf *vf, u8 *msg)
struct i40e_pf *pf = vf->pf;
i40e_status aq_ret = 0;
/* Immediately mark queues as disabled */
vf->queues_enabled = false;
if (!test_bit(I40E_VF_STATE_ACTIVE, &vf->vf_states)) {
aq_ret = I40E_ERR_PARAM;
goto error_param;
......
......@@ -98,7 +98,6 @@ struct i40e_vf {
unsigned int tx_rate; /* Tx bandwidth limit in Mbps */
bool link_forced;
bool link_up; /* only valid if VF link is forced */
bool queues_enabled; /* true if the VF queues are enabled */
bool spoofchk;
u16 num_vlan;
......
......@@ -1714,7 +1714,8 @@ static int igc_ethtool_get_link_ksettings(struct net_device *netdev,
Asym_Pause);
}
status = rd32(IGC_STATUS);
status = pm_runtime_suspended(&adapter->pdev->dev) ?
0 : rd32(IGC_STATUS);
if (status & IGC_STATUS_LU) {
if (status & IGC_STATUS_SPEED_1000) {
......
......@@ -219,9 +219,9 @@ static s32 igc_write_nvm_srwr(struct igc_hw *hw, u16 offset, u16 words,
u16 *data)
{
struct igc_nvm_info *nvm = &hw->nvm;
s32 ret_val = -IGC_ERR_NVM;
u32 attempts = 100000;
u32 i, k, eewr = 0;
s32 ret_val = 0;
/* A check for invalid values: offset too large, too many words,
* too many words for the offset, and not enough words.
......@@ -229,7 +229,6 @@ static s32 igc_write_nvm_srwr(struct igc_hw *hw, u16 offset, u16 words,
if (offset >= nvm->word_size || (words > (nvm->word_size - offset)) ||
words == 0) {
hw_dbg("nvm parameter(s) out of bounds\n");
ret_val = -IGC_ERR_NVM;
goto out;
}
......
......@@ -638,7 +638,7 @@ s32 igc_config_fc_after_link_up(struct igc_hw *hw)
}
out:
return 0;
return ret_val;
}
/**
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment