thermal: core: Do not fail cdev registration because of invalid initial state

It is reported that commit 31a0fa00 ("thermal/debugfs: Pass cooling
device state to thermal_debug_cdev_add()") causes the ACPI fan driver
to fail probing on some systems which turns out to be due to the _FST
control method returning an invalid value until _FSL is first evaluated
for the given fan.  If this happens, the .get_cur_state() cooling device
callback returns an error and __thermal_cooling_device_register() fails
as uses that callback after commit 31a0fa00.

Arguably, _FST should not return an invalid value even if it is
evaluated before _FSL, so this may be regarded as a platform firmware
issue, but at the same time it is not a good enough reason for failing
the cooling device registration where the initial cooling device state
is only needed to initialize a thermal debug facility.

Accordingly, modify __thermal_cooling_device_register() to avoid
calling thermal_debug_cdev_add() instead of returning an error if the
initial .get_cur_state() callback invocation fails.

Fixes: 31a0fa00 ("thermal/debugfs: Pass cooling device state to thermal_debug_cdev_add()")
Closes: https://lore.kernel.org/linux-acpi/20240530153727.843378-1-laura.nao@collabora.comReported-by: Laura Nao <laura.nao@collabora.com>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
Acked-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Tested-by: Laura Nao <laura.nao@collabora.com>

drivers/thermal/thermal_core.c

@@ -999,9 +999,17 @@ __thermal_cooling_device_register(struct device_node *np,
 	if (ret)
 		goto out_cdev_type;
 
+	/*
+	 * The cooling device's current state is only needed for debug
+	 * initialization below, so a failure to get it does not cause
+	 * the entire cooling device initialization to fail.  However,
+	 * the debug will not work for the device if its initial state
+	 * cannot be determined and drivers are responsible for ensuring
+	 * that this will not happen.
+	 */
 	ret = cdev->ops->get_cur_state(cdev, &current_state);
 	if (ret)
-		goto out_cdev_type;
+		current_state = ULONG_MAX;
 
 	thermal_cooling_device_setup_sysfs(cdev);
 
@@ -1016,7 +1024,8 @@ __thermal_cooling_device_register(struct device_node *np,
 		return ERR_PTR(ret);
 	}
 
-	thermal_debug_cdev_add(cdev, current_state);
+	if (current_state <= cdev->max_state)
+		thermal_debug_cdev_add(cdev, current_state);
 
 	/* Add 'this' new cdev to the global cdev list */
 	mutex_lock(&thermal_list_lock);