arm64: dts: qcom: sm8350: fix the node unit addresses

Some node unit addresses were put wrongly in the dts, resulting in
below warning when run with W=1

arch/arm64/boot/dts/qcom/sm8350.dtsi:693.34-702.5: Warning (simple_bus_reg): /soc@0/thermal-sensor@c222000: simple-bus unit address format error, expected "c263000"
arch/arm64/boot/dts/qcom/sm8350.dtsi:704.34-713.5: Warning (simple_bus_reg): /soc@0/thermal-sensor@c223000: simple-bus unit address format error, expected "c265000"
arch/arm64/boot/dts/qcom/sm8350.dtsi:1180.32-1185.5: Warning (simple_bus_reg): /soc@0/interconnect@90e0000: simple-bus unit address format error, expected "90c0000"

Fix by correcting to the correct address as given in reg node
Reviewed-by: Robert Foss <robert.foss@linaro.org>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
Link: https://lore.kernel.org/r/20210513060733.382420-1-vkoul@kernel.orgSigned-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

arch/arm64/boot/dts/qcom/sm8350.dtsi

@@ -741,7 +741,7 @@ pdc: interrupt-controller@b220000 {
 			interrupt-controller;
 		};
 
-		tsens0: thermal-sensor@c222000 {
+		tsens0: thermal-sensor@c263000 {
 			compatible = "qcom,sm8350-tsens", "qcom,tsens-v2";
 			reg = <0 0x0c263000 0 0x1ff>, /* TM */
 			      <0 0x0c222000 0 0x8>; /* SROT */
@@ -752,7 +752,7 @@ tsens0: thermal-sensor@c222000 {
 			#thermal-sensor-cells = <1>;
 		};
 
-		tsens1: thermal-sensor@c223000 {
+		tsens1: thermal-sensor@c265000 {
 			compatible = "qcom,sm8350-tsens", "qcom,tsens-v2";
 			reg = <0 0x0c265000 0 0x1ff>, /* TM */
 			      <0 0x0c223000 0 0x8>; /* SROT */
@@ -1228,7 +1228,7 @@ usb_2_ssphy: phy@88ebe00 {
 			};
 		};
 
-		dc_noc: interconnect@90e0000 {
+		dc_noc: interconnect@90c0000 {
 			compatible = "qcom,sm8350-dc-noc";
 			reg = <0 0x090c0000 0 0x4200>;
 			#interconnect-cells = <1>;