bpf: prevent r10 register from being marked as precise

r10 is a special register that is not under BPF program's control and is
always effectively precise. The rest of precision logic assumes that
only r0-r9 SCALAR registers are marked as precise, so prevent r10 from
being marked precise.

This can happen due to signed cast instruction allowing to do something
like `r0 = (s8)r10;`, which later, if r0 needs to be precise, would lead
to an attempt to mark r10 as precise.

Prevent this with an extra check during instruction backtracking.

Fixes: 8100928c ("bpf: Support new sign-extension mov insns")
Reported-by: syzbot+148110ee7cf72f39f33e@syzkaller.appspotmail.com
Signed-off-by: Andrii Nakryiko <andrii@kernel.org>
Acked-by: Yonghong Song <yonghong.song@linux.dev>
Link: https://lore.kernel.org/r/20240404214536.3551295-1-andrii@kernel.orgSigned-off-by: Alexei Starovoitov <ast@kernel.org>

kernel/bpf/verifier.c

@@ -3615,7 +3615,8 @@ static int backtrack_insn(struct bpf_verifier_env *env, int idx, int subseq_idx,
 				 * sreg needs precision before this insn
 				 */
 				bt_clear_reg(bt, dreg);
-				bt_set_reg(bt, sreg);
+				if (sreg != BPF_REG_FP)
+					bt_set_reg(bt, sreg);
 			} else {
 				/* dreg = K
 				 * dreg needs precision after this insn.
@@ -3631,7 +3632,8 @@ static int backtrack_insn(struct bpf_verifier_env *env, int idx, int subseq_idx,
 				 * both dreg and sreg need precision
 				 * before this insn
 				 */
-				bt_set_reg(bt, sreg);
+				if (sreg != BPF_REG_FP)
+					bt_set_reg(bt, sreg);
 			} /* else dreg += K
 			   * dreg still needs precision before this insn
 			   */