iio: adc: ad_sigma_delta: do not use internal iio_dev lock

Drop 'mlock' usage by making use of iio_device_claim_direct_mode().
This change actually makes sure we cannot do a single conversion while
buffering is enable. Note there was a potential race in the previous
code since we were only acquiring the lock after checking if the bus is
enabled.

Fixes: af300848 ("iio:adc: Add common code for ADI Sigma Delta devices")
Signed-off-by: Nuno Sá <nuno.sa@analog.com>
Reviewed-by: Miquel Raynal <miquel.raynal@bootlin.com>
Cc: <Stable@vger.kernel.org> #No rush as race is very old.
Link: https://lore.kernel.org/r/20220920112821.975359-2-nuno.sa@analog.comSigned-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>

drivers/iio/adc/ad_sigma_delta.c

@@ -281,10 +281,10 @@ int ad_sigma_delta_single_conversion(struct iio_dev *indio_dev,
 	unsigned int data_reg;
 	int ret = 0;
 
-	if (iio_buffer_enabled(indio_dev))
-		return -EBUSY;
+	ret = iio_device_claim_direct_mode(indio_dev);
+	if (ret)
+		return ret;
 
-	mutex_lock(&indio_dev->mlock);
 	ad_sigma_delta_set_channel(sigma_delta, chan->address);
 
 	spi_bus_lock(sigma_delta->spi->master);
@@ -323,7 +323,7 @@ int ad_sigma_delta_single_conversion(struct iio_dev *indio_dev,
 	ad_sigma_delta_set_mode(sigma_delta, AD_SD_MODE_IDLE);
 	sigma_delta->bus_locked = false;
 	spi_bus_unlock(sigma_delta->spi->master);
-	mutex_unlock(&indio_dev->mlock);
+	iio_device_release_direct_mode(indio_dev);
 
 	if (ret)
 		return ret;