Commit 209e5ac8 authored by Francois Romieu's avatar Francois Romieu

r8169: remove rtl8169_reinit_task.

I see no good reason to keep both rtl8169_reinit_task and rtl8169_reset_task:
- rtl8169_reinit_task adds a software failure point which does relate to
  any hardware state
- they handle hardware the same. Remember that rtl8169_reinit_task was
  introduced in the 8169 only era to handle PCI errors way before the 8168
  asked for pll and firmware ops and compare :

      rtl8169_reinit_task     |    rtl8169_reset_task
  ----------------------------+--------------------------
  rtl8169_wait_for_quiescence | rtl8169_hw_reset
  rtl8169_update_counters     | rtl8169_wait_for_quiescence
  rtl8169_hw_reset            | rtl_hw_start
  rtl8169_rx_missed           | rtl8169_check_link_status
  rtl_pll_power_down          |
  rtl_request_firmware        |
  rtl8169_init_phy            |
  rtl_pll_power_up            |
  rtl_hw_start                |
  rtl8169_check_link_status   |
Signed-off-by: default avatarFrancois Romieu <romieu@fr.zoreil.com>
Cc: Hayes Wang <hayeswang@realtek.com>
parent 4512ff9f
......@@ -5353,34 +5353,6 @@ static void rtl8169_wait_for_quiescence(struct net_device *dev)
napi_enable(&tp->napi);
}
static void rtl8169_reinit_task(struct work_struct *work)
{
struct rtl8169_private *tp =
container_of(work, struct rtl8169_private, task.work);
struct net_device *dev = tp->dev;
int ret;
rtnl_lock();
if (!netif_running(dev))
goto out_unlock;
rtl8169_wait_for_quiescence(dev);
rtl8169_close(dev);
ret = rtl8169_open(dev);
if (unlikely(ret < 0)) {
if (net_ratelimit())
netif_err(tp, drv, dev,
"reinit failure (status = %d). Rescheduling\n",
ret);
rtl8169_schedule_work(dev, rtl8169_reinit_task);
}
out_unlock:
rtnl_unlock();
}
static void rtl8169_reset_task(struct work_struct *work)
{
struct rtl8169_private *tp =
......@@ -5616,7 +5588,7 @@ static void rtl8169_pcierr_interrupt(struct net_device *dev)
rtl8169_hw_reset(tp);
rtl8169_schedule_work(dev, rtl8169_reinit_task);
rtl8169_schedule_work(dev, rtl8169_reset_task);
}
static void rtl8169_tx_interrupt(struct net_device *dev,
......@@ -5923,8 +5895,8 @@ static void rtl8169_down(struct net_device *dev)
rtl8169_hw_reset(tp);
/*
* At this point device interrupts can not be enabled in any function,
* as netif_running is not true (rtl8169_interrupt, rtl8169_reset_task,
* rtl8169_reinit_task) and napi is disabled (rtl8169_poll).
* as netif_running is not true (rtl8169_interrupt, rtl8169_reset_task)
* and napi is disabled (rtl8169_poll).
*/
rtl8169_rx_missed(dev, ioaddr);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment