Commit 20e681fd authored by Greg Ungerer's avatar Greg Ungerer

m68knommu: make 527x UART platform addressing consistent

If we make all UART addressing consistent across all ColdFire family members
then we will be able to remove the duplicated plaform data and use a single
setup for all.

So modify the ColdFire 527x UART addressing so that:

. UARTs are numbered from 0 up
. use a common name for IRQs used
Signed-off-by: default avatarGreg Ungerer <gerg@uclinux.org>
parent 023e0555
...@@ -40,6 +40,10 @@ ...@@ -40,6 +40,10 @@
#define MCFINT_QSPI 18 /* Interrupt number for QSPI */ #define MCFINT_QSPI 18 /* Interrupt number for QSPI */
#define MCFINT_PIT1 36 /* Interrupt number for PIT1 */ #define MCFINT_PIT1 36 /* Interrupt number for PIT1 */
#define MCF_IRQ_UART0 (MCFINT_VECBASE + MCFINT_UART0)
#define MCF_IRQ_UART1 (MCFINT_VECBASE + MCFINT_UART1)
#define MCF_IRQ_UART2 (MCFINT_VECBASE + MCFINT_UART2)
/* /*
* SDRAM configuration registers. * SDRAM configuration registers.
*/ */
...@@ -72,9 +76,9 @@ ...@@ -72,9 +76,9 @@
/* /*
* UART module. * UART module.
*/ */
#define MCFUART_BASE1 (MCF_IPSBAR + 0x200) #define MCFUART_BASE0 (MCF_IPSBAR + 0x200)
#define MCFUART_BASE2 (MCF_IPSBAR + 0x240) #define MCFUART_BASE1 (MCF_IPSBAR + 0x240)
#define MCFUART_BASE3 (MCF_IPSBAR + 0x280) #define MCFUART_BASE2 (MCF_IPSBAR + 0x280)
/* /*
* FEC ethernet module. * FEC ethernet module.
......
...@@ -28,16 +28,16 @@ ...@@ -28,16 +28,16 @@
static struct mcf_platform_uart m527x_uart_platform[] = { static struct mcf_platform_uart m527x_uart_platform[] = {
{ {
.mapbase = MCFUART_BASE1, .mapbase = MCFUART_BASE0,
.irq = MCFINT_VECBASE + MCFINT_UART0, .irq = MCF_IRQ_UART0,
}, },
{ {
.mapbase = MCFUART_BASE2, .mapbase = MCFUART_BASE1,
.irq = MCFINT_VECBASE + MCFINT_UART1, .irq = MCF_IRQ_UART1,
}, },
{ {
.mapbase = MCFUART_BASE3, .mapbase = MCFUART_BASE2,
.irq = MCFINT_VECBASE + MCFINT_UART2, .irq = MCF_IRQ_UART2,
}, },
{ }, { },
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment