Commit 22259471 authored by René van Dorst's avatar René van Dorst Committed by David S. Miller

net: dsa: mt7530: Change the LINK bit to reflect the link status

Andrew reported:

After a number of network port link up/down changes, sometimes the switch
port gets stuck in a state where it thinks it is still transmitting packets
but the cpu port is not actually transmitting anymore. In this state you
will see a message on the console
"mtk_soc_eth 1e100000.ethernet eth0: transmit timed out" and the Tx counter
in ifconfig will be incrementing on virtual port, but not incrementing on
cpu port.

The issue is that MAC TX/RX status has no impact on the link status or
queue manager of the switch. So the queue manager just queues up packets
of a disabled port and sends out pause frames when the queue is full.

Change the LINK bit to reflect the link status.

Fixes: b8f126a8 ("net-next: dsa: add dsa support for Mediatek MT7530 switch")
Reported-by: default avatarAndrew Smith <andrew.smith@digi.com>
Signed-off-by: default avatarRené van Dorst <opensource@vdorst.com>
Reviewed-by: default avatarVivien Didelot <vivien.didelot@gmail.com>
Reviewed-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 3ac9eb42
......@@ -566,7 +566,7 @@ mt7530_mib_reset(struct dsa_switch *ds)
static void
mt7530_port_set_status(struct mt7530_priv *priv, int port, int enable)
{
u32 mask = PMCR_TX_EN | PMCR_RX_EN;
u32 mask = PMCR_TX_EN | PMCR_RX_EN | PMCR_FORCE_LNK;
if (enable)
mt7530_set(priv, MT7530_PMCR_P(port), mask);
......@@ -1444,7 +1444,7 @@ static void mt7530_phylink_mac_config(struct dsa_switch *ds, int port,
mcr_new &= ~(PMCR_FORCE_SPEED_1000 | PMCR_FORCE_SPEED_100 |
PMCR_FORCE_FDX | PMCR_TX_FC_EN | PMCR_RX_FC_EN);
mcr_new |= PMCR_IFG_XMIT(1) | PMCR_MAC_MODE | PMCR_BACKOFF_EN |
PMCR_BACKPR_EN | PMCR_FORCE_MODE | PMCR_FORCE_LNK;
PMCR_BACKPR_EN | PMCR_FORCE_MODE;
/* Are we connected to external phy */
if (port == 5 && dsa_is_user_port(ds, 5))
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment