Commit 27896c83 authored by Ard Biesheuvel's avatar Ard Biesheuvel Committed by David S. Miller

r8169: default to 64-bit DMA on recent PCIe chips

The current logic around the 'use_dac' module parameter prevents the
r81969 driver from being loadable on 64-bit systems without any RAM
below 4 GB when the parameter is left at its default value.

So introduce a new default value -1 which indicates that 64-bit DMA
should be enabled on sufficiently recent PCIe chips, i.e., versions
RTL_GIGA_MAC_VER_18 or later. Explicit param values of 0 or 1 retain
the existing behavior of unconditionally enabling/disabling 64-bit DMA
on 64-bit architectures (i.e., regardless of the type and version of the
chip)

Since PCIe chips do not need to CPlusCmd Dual Address Cycle to be set,
make that conditional on the device type as well.

Cc: Realtek linux nic maintainers <nic_swsd@realtek.com>
Signed-off-by: default avatarArd Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 81003bc9
......@@ -345,7 +345,7 @@ static const struct pci_device_id rtl8169_pci_tbl[] = {
MODULE_DEVICE_TABLE(pci, rtl8169_pci_tbl);
static int rx_buf_sz = 16383;
static int use_dac;
static int use_dac = -1;
static struct {
u32 msg_enable;
} debug = { -1 };
......@@ -8224,20 +8224,6 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
goto err_out_mwi_2;
}
tp->cp_cmd = 0;
if ((sizeof(dma_addr_t) > 4) &&
!pci_set_dma_mask(pdev, DMA_BIT_MASK(64)) && use_dac) {
tp->cp_cmd |= PCIDAC;
dev->features |= NETIF_F_HIGHDMA;
} else {
rc = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
if (rc < 0) {
netif_err(tp, probe, dev, "DMA configuration failed\n");
goto err_out_free_res_3;
}
}
/* ioremap MMIO region */
ioaddr = ioremap(pci_resource_start(pdev, region), R8169_REGS_SIZE);
if (!ioaddr) {
......@@ -8253,6 +8239,25 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
/* Identify chip attached to board */
rtl8169_get_mac_version(tp, dev, cfg->default_ver);
tp->cp_cmd = 0;
if ((sizeof(dma_addr_t) > 4) &&
(use_dac == 1 || (use_dac == -1 && pci_is_pcie(pdev) &&
tp->mac_version >= RTL_GIGA_MAC_VER_18)) &&
!pci_set_dma_mask(pdev, DMA_BIT_MASK(64))) {
/* CPlusCmd Dual Access Cycle is only needed for non-PCIe */
if (!pci_is_pcie(pdev))
tp->cp_cmd |= PCIDAC;
dev->features |= NETIF_F_HIGHDMA;
} else {
rc = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
if (rc < 0) {
netif_err(tp, probe, dev, "DMA configuration failed\n");
goto err_out_unmap_4;
}
}
rtl_init_rxcfg(tp);
rtl_irq_disable(tp);
......@@ -8412,12 +8417,12 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
&tp->counters_phys_addr, GFP_KERNEL);
if (!tp->counters) {
rc = -ENOMEM;
goto err_out_msi_4;
goto err_out_msi_5;
}
rc = register_netdev(dev);
if (rc < 0)
goto err_out_cnt_5;
goto err_out_cnt_6;
pci_set_drvdata(pdev, dev);
......@@ -8451,12 +8456,13 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
out:
return rc;
err_out_cnt_5:
err_out_cnt_6:
dma_free_coherent(&pdev->dev, sizeof(*tp->counters), tp->counters,
tp->counters_phys_addr);
err_out_msi_4:
err_out_msi_5:
netif_napi_del(&tp->napi);
rtl_disable_msi(pdev, tp);
err_out_unmap_4:
iounmap(ioaddr);
err_out_free_res_3:
pci_release_regions(pdev);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment