Commit 2a609abe authored by Andy Shevchenko's avatar Andy Shevchenko Committed by Ulf Hansson

sdhci: Advertise 2.0v supply on SDIO host controller

On Intel Edison the Broadcom Wi-Fi card, which is connected to SDIO,
requires 2.0v, while the host, according to Intel Merrifield TRM,
supports 1.8v supply only.

The card announces itself as

  mmc2: new ultra high speed DDR50 SDIO card at address 0001

Introduce a custom OCR mask for SDIO host controller on Intel Merrifield
and add a special case to sdhci_set_power_noreg() to override 2.0v supply
by enforcing 1.8v power choice.
Signed-off-by: default avatarAndy Shevchenko <andriy.shevchenko@linux.intel.com>
Acked-by: default avatarAdrian Hunter <adrian.hunter@intel.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent b8155d3f
......@@ -930,6 +930,8 @@ static int intel_mrfld_mmc_probe_slot(struct sdhci_pci_slot *slot)
slot->host->quirks2 |= SDHCI_QUIRK2_NO_1_8_V;
break;
case INTEL_MRFLD_SDIO:
/* Advertise 2.0v for compatibility with the SDIO card's OCR */
slot->host->ocr_mask = MMC_VDD_20_21 | MMC_VDD_165_195;
slot->host->mmc->caps |= MMC_CAP_NONREMOVABLE |
MMC_CAP_POWER_OFF_CARD;
break;
......
......@@ -1434,6 +1434,13 @@ void sdhci_set_power_noreg(struct sdhci_host *host, unsigned char mode,
if (mode != MMC_POWER_OFF) {
switch (1 << vdd) {
case MMC_VDD_165_195:
/*
* Without a regulator, SDHCI does not support 2.0v
* so we only get here if the driver deliberately
* added the 2.0v range to ocr_avail. Map it to 1.8v
* for the purpose of turning on the power.
*/
case MMC_VDD_20_21:
pwr = SDHCI_POWER_180;
break;
case MMC_VDD_29_30:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment