Commit 2d4bcbed authored by Carl Huang's avatar Carl Huang Committed by Kalle Valo

ath11k: initialize wmi config based on hw_params

QCA6390 has very different wmi config parameters compared to IPQ8074,
so use different function to initialize wmi init config parameters.

Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.1.0.1-01238-QCAHKSWPL_SILICONZ-2
Signed-off-by: default avatarCarl Huang <cjhuang@codeaurora.org>
Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/1597576599-8857-11-git-send-email-kvalo@codeaurora.org
parent 5f859bc0
......@@ -31,12 +31,110 @@ static u8 ath11k_hw_ipq6018_mac_from_pdev_id(int pdev_idx)
return pdev_idx;
}
static void ath11k_init_wmi_config_qca6390(struct ath11k_base *ab,
struct target_resource_config *config)
{
config->num_vdevs = 4;
config->num_peers = 16;
config->num_tids = 32;
config->num_offload_peers = 3;
config->num_offload_reorder_buffs = 3;
config->num_peer_keys = TARGET_NUM_PEER_KEYS;
config->ast_skid_limit = TARGET_AST_SKID_LIMIT;
config->tx_chain_mask = (1 << ab->target_caps.num_rf_chains) - 1;
config->rx_chain_mask = (1 << ab->target_caps.num_rf_chains) - 1;
config->rx_timeout_pri[0] = TARGET_RX_TIMEOUT_LO_PRI;
config->rx_timeout_pri[1] = TARGET_RX_TIMEOUT_LO_PRI;
config->rx_timeout_pri[2] = TARGET_RX_TIMEOUT_LO_PRI;
config->rx_timeout_pri[3] = TARGET_RX_TIMEOUT_HI_PRI;
config->rx_decap_mode = TARGET_DECAP_MODE_NATIVE_WIFI;
config->scan_max_pending_req = TARGET_SCAN_MAX_PENDING_REQS;
config->bmiss_offload_max_vdev = TARGET_BMISS_OFFLOAD_MAX_VDEV;
config->roam_offload_max_vdev = TARGET_ROAM_OFFLOAD_MAX_VDEV;
config->roam_offload_max_ap_profiles = TARGET_ROAM_OFFLOAD_MAX_AP_PROFILES;
config->num_mcast_groups = 0;
config->num_mcast_table_elems = 0;
config->mcast2ucast_mode = 0;
config->tx_dbg_log_size = TARGET_TX_DBG_LOG_SIZE;
config->num_wds_entries = 0;
config->dma_burst_size = 0;
config->rx_skip_defrag_timeout_dup_detection_check = 0;
config->vow_config = TARGET_VOW_CONFIG;
config->gtk_offload_max_vdev = 2;
config->num_msdu_desc = 0x400;
config->beacon_tx_offload_max_vdev = 2;
config->rx_batchmode = TARGET_RX_BATCHMODE;
config->peer_map_unmap_v2_support = 0;
config->use_pdev_id = 1;
config->max_frag_entries = 0xa;
config->num_tdls_vdevs = 0x1;
config->num_tdls_conn_table_entries = 8;
config->beacon_tx_offload_max_vdev = 0x2;
config->num_multicast_filter_entries = 0x20;
config->num_wow_filters = 0x16;
config->num_keep_alive_pattern = 0x1;
config->num_keep_alive_pattern = 0;
}
static void ath11k_init_wmi_config_ipq8074(struct ath11k_base *ab,
struct target_resource_config *config)
{
config->num_vdevs = ab->num_radios * TARGET_NUM_VDEVS;
if (ab->num_radios == 2) {
config->num_peers = TARGET_NUM_PEERS(DBS);
config->num_tids = TARGET_NUM_TIDS(DBS);
} else if (ab->num_radios == 3) {
config->num_peers = TARGET_NUM_PEERS(DBS_SBS);
config->num_tids = TARGET_NUM_TIDS(DBS_SBS);
} else {
/* Control should not reach here */
config->num_peers = TARGET_NUM_PEERS(SINGLE);
config->num_tids = TARGET_NUM_TIDS(SINGLE);
}
config->num_offload_peers = TARGET_NUM_OFFLD_PEERS;
config->num_offload_reorder_buffs = TARGET_NUM_OFFLD_REORDER_BUFFS;
config->num_peer_keys = TARGET_NUM_PEER_KEYS;
config->ast_skid_limit = TARGET_AST_SKID_LIMIT;
config->tx_chain_mask = (1 << ab->target_caps.num_rf_chains) - 1;
config->rx_chain_mask = (1 << ab->target_caps.num_rf_chains) - 1;
config->rx_timeout_pri[0] = TARGET_RX_TIMEOUT_LO_PRI;
config->rx_timeout_pri[1] = TARGET_RX_TIMEOUT_LO_PRI;
config->rx_timeout_pri[2] = TARGET_RX_TIMEOUT_LO_PRI;
config->rx_timeout_pri[3] = TARGET_RX_TIMEOUT_HI_PRI;
config->rx_decap_mode = TARGET_DECAP_MODE_NATIVE_WIFI;
config->scan_max_pending_req = TARGET_SCAN_MAX_PENDING_REQS;
config->bmiss_offload_max_vdev = TARGET_BMISS_OFFLOAD_MAX_VDEV;
config->roam_offload_max_vdev = TARGET_ROAM_OFFLOAD_MAX_VDEV;
config->roam_offload_max_ap_profiles = TARGET_ROAM_OFFLOAD_MAX_AP_PROFILES;
config->num_mcast_groups = TARGET_NUM_MCAST_GROUPS;
config->num_mcast_table_elems = TARGET_NUM_MCAST_TABLE_ELEMS;
config->mcast2ucast_mode = TARGET_MCAST2UCAST_MODE;
config->tx_dbg_log_size = TARGET_TX_DBG_LOG_SIZE;
config->num_wds_entries = TARGET_NUM_WDS_ENTRIES;
config->dma_burst_size = TARGET_DMA_BURST_SIZE;
config->rx_skip_defrag_timeout_dup_detection_check =
TARGET_RX_SKIP_DEFRAG_TIMEOUT_DUP_DETECTION_CHECK;
config->vow_config = TARGET_VOW_CONFIG;
config->gtk_offload_max_vdev = TARGET_GTK_OFFLOAD_MAX_VDEV;
config->num_msdu_desc = TARGET_NUM_MSDU_DESC;
config->beacon_tx_offload_max_vdev = ab->num_radios * TARGET_MAX_BCN_OFFLD;
config->rx_batchmode = TARGET_RX_BATCHMODE;
config->peer_map_unmap_v2_support = 1;
config->twt_ap_pdev_count = 2;
config->twt_ap_sta_count = 1000;
}
const struct ath11k_hw_ops ipq8074_ops = {
.get_hw_mac_from_pdev_id = ath11k_hw_ipq8074_mac_from_pdev_id,
.wmi_init_config = ath11k_init_wmi_config_qca6390,
};
const struct ath11k_hw_ops ipq6018_ops = {
.get_hw_mac_from_pdev_id = ath11k_hw_ipq6018_mac_from_pdev_id,
.wmi_init_config = ath11k_init_wmi_config_ipq8074,
};
const struct ath11k_hw_ops qca6390_ops = {
......
......@@ -6,6 +6,8 @@
#ifndef ATH11K_HW_H
#define ATH11K_HW_H
#include "wmi.h"
/* Target configuration defines */
/* Num VDEVS per radio */
......@@ -116,6 +118,8 @@ struct ath11k_hw_ring_mask {
struct ath11k_hw_ops {
u8 (*get_hw_mac_from_pdev_id)(int pdev_id);
void (*wmi_init_config)(struct ath11k_base *ab,
struct target_resource_config *config);
};
struct ath11k_hw_params {
......
......@@ -3181,7 +3181,7 @@ static int ath11k_init_cmd_send(struct ath11k_pdev_wmi *wmi,
(param->num_band_to_mac * sizeof(*band_to_mac));
len = sizeof(*cmd) + TLV_HDR_SIZE + sizeof(*cfg) + hw_mode_len +
(sizeof(*host_mem_chunks) * WMI_MAX_MEM_REQS);
(param->num_mem_chunks ? (sizeof(*host_mem_chunks) * WMI_MAX_MEM_REQS) : 0);
skb = ath11k_wmi_alloc_skb(wmi->wmi_ab, len);
if (!skb)
......@@ -3387,6 +3387,8 @@ int ath11k_wmi_cmd_init(struct ath11k_base *ab)
config.twt_ap_pdev_count = ab->num_radios;
config.twt_ap_sta_count = 1000;
ab->hw_params.hw_ops->wmi_init_config(ab, &config);
memcpy(&wmi_sc->wlan_resource_config, &config, sizeof(config));
init_param.res_cfg = &wmi_sc->wlan_resource_config;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment