Commit 2e7e65ce authored by Wolfram Sang's avatar Wolfram Sang Committed by Liam Girdwood

regulator: fix typos

Fix a couple of typos I found while working with this subsystem.
Signed-off-by: default avatarWolfram Sang <w.sang@pengutronix.de>
Acked-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: default avatarLiam Girdwood <lrg@slimlogic.co.uk>
parent 656d0498
......@@ -87,7 +87,7 @@ static struct platform_device regulator_devices[] = {
},
};
/* register regulator 1 device */
platform_device_register(&wm8350_regulator_devices[0]);
platform_device_register(&regulator_devices[0]);
/* register regulator 2 device */
platform_device_register(&wm8350_regulator_devices[1]);
platform_device_register(&regulator_devices[1]);
......@@ -41,7 +41,7 @@ struct regulator;
#define REGULATOR_CHANGE_DRMS 0x10
/**
* struct regulator_state - regulator state during low power syatem states
* struct regulator_state - regulator state during low power system states
*
* This describes a regulators state during a system wide low power state.
*
......@@ -117,10 +117,10 @@ struct regulation_constraints {
/* mode to set on startup */
unsigned int initial_mode;
/* constriant flags */
/* constraint flags */
unsigned always_on:1; /* regulator never off when system is on */
unsigned boot_on:1; /* bootloader/firmware enabled regulator */
unsigned apply_uV:1; /* apply uV constraint iff min == max */
unsigned apply_uV:1; /* apply uV constraint if min == max */
};
/**
......
......@@ -36,7 +36,7 @@
* max1586_subdev_data - regulator data
* @id: regulator Id (either MAX1586_V3 or MAX1586_V6)
* @name: regulator cute name (example for V3: "vcc_core")
* @platform_data: regulator init data (contraints, supplies, ...)
* @platform_data: regulator init data (constraints, supplies, ...)
*/
struct max1586_subdev_data {
int id;
......@@ -46,7 +46,7 @@ struct max1586_subdev_data {
/**
* max1586_platform_data - platform data for max1586
* @num_subdevs: number of regultors used (may be 1 or 2)
* @num_subdevs: number of regulators used (may be 1 or 2)
* @subdevs: regulator used
* At most, there will be a regulator for V3 and one for V6 voltages.
* @v3_gain: gain on the V3 voltage output multiplied by 1e6.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment