gpio: Remove sta2x11 GPIO driver

The Connext chip has 4 gpio cells looking very similar to those of the
Nomadik, whose gpio/pinctrl driver (already featuring devicetree support)
will be used instead of the sta2x11 specific one.
Signed-off-by: Davide Ciminaghi <ciminaghi@gnudd.com>
Acked-by: Giancarlo Asnaghi <giancarlo.asnaghi@st.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Christophe Leroy <christophe.leroy@csgroup.eu>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

drivers/gpio/Kconfig

@@ -600,14 +600,6 @@ config GPIO_SPRD
 	help
 	  Say yes here to support Spreadtrum GPIO device.
 
-config GPIO_STA2X11
-	bool "STA2x11/ConneXt GPIO support"
-	depends on MFD_STA2X11
-	select GENERIC_IRQ_CHIP
-	help
-	  Say yes here to support the STA2x11/ConneXt GPIO device.
-	  The GPIO module has 128 GPIO pins with alternate functions.
-
 config GPIO_STP_XWAY
 	bool "XWAY STP GPIOs"
 	depends on SOC_XWAY || COMPILE_TEST

drivers/gpio/Makefile

@@ -140,7 +140,6 @@ obj-$(CONFIG_GPIO_SL28CPLD)		+= gpio-sl28cpld.o
 obj-$(CONFIG_GPIO_SODAVILLE)		+= gpio-sodaville.o
 obj-$(CONFIG_GPIO_SPEAR_SPICS)		+= gpio-spear-spics.o
 obj-$(CONFIG_GPIO_SPRD)			+= gpio-sprd.o
-obj-$(CONFIG_GPIO_STA2X11)		+= gpio-sta2x11.o
 obj-$(CONFIG_GPIO_STMPE)		+= gpio-stmpe.o
 obj-$(CONFIG_GPIO_STP_XWAY)		+= gpio-stp-xway.o
 obj-$(CONFIG_GPIO_SYSCON)		+= gpio-syscon.o