ARM: shmobile: INTC External IRQ pin driver on sh73a0
Adjust the sh73a0 IRQ code to make use of the INTC External IRQ pin driver for external interrupt pins IRQ0 -> IRQ31. This removes quite a bit of special-case code in intc-sh73a0.c but the number of lines get replaced with platform device information in setup-sh73a0.c. The PFC code is also adjusted to make gpio_to_irq() return the correct interrupt number. At this point the DT reference implementations are not covered. In the future such code shall tie in the INTC External IRQ pin driver via DT, so this kind of verbose code is not needed for the long term DT case. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
Showing