iwlwifi: do not re-configure HT40 after associated
The ht40 setting should not change after association unless channel switch This fix a problem we are seeing which cause uCode assert because driver sending invalid information and make uCode confuse Here is the firmware assert message: kernel: iwlagn 0000:03:00.0: Microcode SW error detected. Restarting 0x82000000. kernel: iwlagn 0000:03:00.0: Loaded firmware version: 17.168.5.3 build 42301 kernel: iwlagn 0000:03:00.0: Start IWL Error Log Dump: kernel: iwlagn 0000:03:00.0: Status: 0x000512E4, count: 6 kernel: iwlagn 0000:03:00.0: 0x00002078 | ADVANCED_SYSASSERT kernel: iwlagn 0000:03:00.0: 0x00009514 | uPc kernel: iwlagn 0000:03:00.0: 0x00009496 | branchlink1 kernel: iwlagn 0000:03:00.0: 0x00009496 | branchlink2 kernel: iwlagn 0000:03:00.0: 0x0000D1F2 | interruptlink1 kernel: iwlagn 0000:03:00.0: 0x00000000 | interruptlink2 kernel: iwlagn 0000:03:00.0: 0x01008035 | data1 kernel: iwlagn 0000:03:00.0: 0x0000C90F | data2 kernel: iwlagn 0000:03:00.0: 0x000005A7 | line kernel: iwlagn 0000:03:00.0: 0x5080B520 | beacon time kernel: iwlagn 0000:03:00.0: 0xCC515AE0 | tsf low kernel: iwlagn 0000:03:00.0: 0x00000003 | tsf hi kernel: iwlagn 0000:03:00.0: 0x00000000 | time gp1 kernel: iwlagn 0000:03:00.0: 0x29703BF0 | time gp2 kernel: iwlagn 0000:03:00.0: 0x00000000 | time gp3 kernel: iwlagn 0000:03:00.0: 0x000111A8 | uCode version kernel: iwlagn 0000:03:00.0: 0x000000B0 | hw version kernel: iwlagn 0000:03:00.0: 0x00480303 | board version kernel: iwlagn 0000:03:00.0: 0x09E8004E | hcmd kernel: iwlagn 0000:03:00.0: CSR values: kernel: iwlagn 0000:03:00.0: (2nd byte of CSR_INT_COALESCING is CSR_INT_PERIODIC_REG) kernel: iwlagn 0000:03:00.0: CSR_HW_IF_CONFIG_REG: 0X00480303 kernel: iwlagn 0000:03:00.0: CSR_INT_COALESCING: 0X0000ff40 kernel: iwlagn 0000:03:00.0: CSR_INT: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_INT_MASK: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_FH_INT_STATUS: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_GPIO_IN: 0X00000030 kernel: iwlagn 0000:03:00.0: CSR_RESET: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_GP_CNTRL: 0X080403c5 kernel: iwlagn 0000:03:00.0: CSR_HW_REV: 0X000000b0 kernel: iwlagn 0000:03:00.0: CSR_EEPROM_REG: 0X07d60ffd kernel: iwlagn 0000:03:00.0: CSR_EEPROM_GP: 0X90000001 kernel: iwlagn 0000:03:00.0: CSR_OTP_GP_REG: 0X00030001 kernel: iwlagn 0000:03:00.0: CSR_GIO_REG: 0X00080044 kernel: iwlagn 0000:03:00.0: CSR_GP_UCODE_REG: 0X000093bb kernel: iwlagn 0000:03:00.0: CSR_GP_DRIVER_REG: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_UCODE_DRV_GP1: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_UCODE_DRV_GP2: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_LED_REG: 0X00000078 kernel: iwlagn 0000:03:00.0: CSR_DRAM_INT_TBL_REG: 0X88214dd2 kernel: iwlagn 0000:03:00.0: CSR_GIO_CHICKEN_BITS: 0X27800200 kernel: iwlagn 0000:03:00.0: CSR_ANA_PLL_CFG: 0X00000000 kernel: iwlagn 0000:03:00.0: CSR_HW_REV_WA_REG: 0X0001001a kernel: iwlagn 0000:03:00.0: CSR_DBG_HPET_MEM_REG: 0Xffff0010 kernel: iwlagn 0000:03:00.0: FH register values: kernel: iwlagn 0000:03:00.0: FH_RSCSR_CHNL0_STTS_WPTR_REG: 0X21316d00 kernel: iwlagn 0000:03:00.0: FH_RSCSR_CHNL0_RBDCB_BASE_REG: 0X021479c0 kernel: iwlagn 0000:03:00.0: FH_RSCSR_CHNL0_WPTR: 0X00000060 kernel: iwlagn 0000:03:00.0: FH_MEM_RCSR_CHNL0_CONFIG_REG: 0X80819104 kernel: iwlagn 0000:03:00.0: FH_MEM_RSSR_SHARED_CTRL_REG: 0X000000fc kernel: iwlagn 0000:03:00.0: FH_MEM_RSSR_RX_STATUS_REG: 0X07030000 kernel: iwlagn 0000:03:00.0: FH_MEM_RSSR_RX_ENABLE_ERR_IRQ2DRV: 0X00000000 kernel: iwlagn 0000:03:00.0: FH_TSSR_TX_STATUS_REG: 0X07ff0001 kernel: iwlagn 0000:03:00.0: FH_TSSR_TX_ERROR_REG: 0X00000000 kernel: iwlagn 0000:03:00.0: Start IWL Event Log Dump: display last 20 entries kernel: ------------[ cut here ]------------ WARNING: at net/mac80211/util.c:1208 ieee80211_reconfig+0x1f1/0x407() kernel: Hardware name: 4290W4H kernel: Pid: 1896, comm: kworker/0:0 Not tainted 3.1.0 #2 kernel: Call Trace: kernel: [<ffffffff81036558>] ? warn_slowpath_common+0x73/0x87 kernel: [<ffffffff813b8966>] ? ieee80211_reconfig+0x1f1/0x407 kernel: [<ffffffff8139e8dc>] ? ieee80211_recalc_smps_work+0x32/0x32 kernel: [<ffffffff8139e95a>] ? ieee80211_restart_work+0x7e/0x87 kernel: [<ffffffff810472fa>] ? process_one_work+0x1c8/0x2e3 kernel: [<ffffffff810480c9>] ? worker_thread+0x17a/0x23a kernel: [<ffffffff81047f4f>] ? manage_workers.clone.18+0x15b/0x15b kernel: [<ffffffff81047f4f>] ? manage_workers.clone.18+0x15b/0x15b kernel: [<ffffffff8104ba97>] ? kthread+0x7a/0x82 kernel: [<ffffffff813d21b4>] ? kernel_thread_helper+0x4/0x10 kernel: [<ffffffff8104ba1d>] ? kthread_flush_work_fn+0x11/0x11 kernel: [<ffffffff813d21b0>] ? gs_change+0xb/0xb Cc: <stable@kernel.org> 3.1+ Reported-by: Udo Steinberg <udo@hypervisor.org> Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
Showing
Please register or sign in to comment