hwmon: (pmbus) Clear pmbus fault/warning bits after read

Almost all fault/warning bits in pmbus status registers remain set even
after fault/warning condition are removed. As per pmbus specification
these faults must be cleared by user.
Modify hwmon behavior to clear fault/warning bit after fetching data if
fault/warning bit was set. This allows to get fresh data in next read.
Signed-off-by: Vikash Chandola <vikash.chandola@linux.intel.com>
Link: https://lore.kernel.org/r/20220222131253.2426834-1-vikash.chandola@linux.intel.comSigned-off-by: Guenter Roeck <linux@roeck-us.net>

drivers/hwmon/pmbus/pmbus_core.c

@@ -911,6 +911,11 @@ static int pmbus_get_boolean(struct i2c_client *client, struct pmbus_boolean *b,
 		pmbus_update_sensor_data(client, s2);
 
 	regval = status & mask;
+	if (regval) {
+		ret = pmbus_write_byte_data(client, page, reg, regval);
+		if (ret)
+			goto unlock;
+	}
 	if (s1 && s2) {
 		s64 v1, v2;