Merge remote-tracking branches 'spi/fix/au1550', 'spi/fix/davinci',...

Merge remote-tracking branches 'spi/fix/au1550', 'spi/fix/davinci', 'spi/fix/doc', 'spi/fix/dw', 'spi/fix/omap-mcspi', 'spi/fix/pxa2xx', 'spi/fix/rockchip' and 'spi/fix/rspi' into spi-linus

drivers/spi/spi-au1550.c

@@ -945,7 +945,7 @@ static int au1550_spi_remove(struct platform_device *pdev)
 	spi_bitbang_stop(&hw->bitbang);
 	free_irq(hw->irq, hw);
 	iounmap((void __iomem *)hw->regs);
-	release_mem_region(r->start, sizeof(psc_spi_t));
+	release_mem_region(hw->ioarea->start, sizeof(psc_spi_t));
 
 	if (hw->usedma) {
 		au1550_spi_dma_rxtmp_free(hw);

drivers/spi/spi-davinci.c

@@ -417,16 +417,16 @@ static int davinci_spi_setup(struct spi_device *spi)
 						  flags, dev_name(&spi->dev));
 			internal_cs = false;
 		}
-	}
 
-	if (retval) {
-		dev_err(&spi->dev, "GPIO %d setup failed (%d)\n",
-			spi->cs_gpio, retval);
-		return retval;
-	}
+		if (retval) {
+			dev_err(&spi->dev, "GPIO %d setup failed (%d)\n",
+				spi->cs_gpio, retval);
+			return retval;
+		}
 
-	if (internal_cs)
-		set_io_bits(dspi->base + SPIPC0, 1 << spi->chip_select);
+		if (internal_cs)
+			set_io_bits(dspi->base + SPIPC0, 1 << spi->chip_select);
+	}
 
 	if (spi->mode & SPI_READY)
 		set_io_bits(dspi->base + SPIPC0, SPIPC0_SPIENA_MASK);

drivers/spi/spi-dw-pci.c

@@ -62,6 +62,8 @@ static int spi_pci_probe(struct pci_dev *pdev,
 	if (ret)
 		return ret;
 
+	dws->regs = pcim_iomap_table(pdev)[pci_bar];
+
 	dws->bus_num = 0;
 	dws->num_cs = 4;
 	dws->irq = pdev->irq;

drivers/spi/spi-dw.c

@@ -271,7 +271,7 @@ static void giveback(struct dw_spi *dws)
 					transfer_list);
 
 	if (!last_transfer->cs_change)
-		spi_chip_sel(dws, dws->cur_msg->spi, 0);
+		spi_chip_sel(dws, msg->spi, 0);
 
 	spi_finalize_current_message(dws->master);
 }

drivers/spi/spi-omap2-mcspi.c

@@ -329,7 +329,8 @@ static void omap2_mcspi_set_fifo(const struct spi_device *spi,
 disable_fifo:
 	if (t->rx_buf != NULL)
 		chconf &= ~OMAP2_MCSPI_CHCONF_FFER;
-	else
+
+	if (t->tx_buf != NULL)
 		chconf &= ~OMAP2_MCSPI_CHCONF_FFET;
 
 	mcspi_write_chconf0(spi, chconf);

drivers/spi/spi-pxa2xx.c

@@ -1074,6 +1074,7 @@ static struct acpi_device_id pxa2xx_spi_acpi_match[] = {
 	{ "INT3430", 0 },
 	{ "INT3431", 0 },
 	{ "80860F0E", 0 },
+	{ "8086228E", 0 },
 	{ },
 };
 MODULE_DEVICE_TABLE(acpi, pxa2xx_spi_acpi_match);

drivers/spi/spi-rockchip.c

@@ -499,7 +499,7 @@ static void rockchip_spi_config(struct rockchip_spi *rs)
 	}
 
 	/* div doesn't support odd number */
-	div = rs->max_freq / rs->speed;
+	div = max_t(u32, rs->max_freq / rs->speed, 1);
 	div = (div + 1) & 0xfffe;
 
 	spi_enable_chip(rs, 0);
@@ -678,7 +678,7 @@ static int rockchip_spi_probe(struct platform_device *pdev)
 		rs->dma_tx.addr = (dma_addr_t)(mem->start + ROCKCHIP_SPI_TXDR);
 		rs->dma_rx.addr = (dma_addr_t)(mem->start + ROCKCHIP_SPI_RXDR);
 		rs->dma_tx.direction = DMA_MEM_TO_DEV;
-		rs->dma_tx.direction = DMA_DEV_TO_MEM;
+		rs->dma_rx.direction = DMA_DEV_TO_MEM;
 
 		master->can_dma = rockchip_spi_can_dma;
 		master->dma_tx = rs->dma_tx.ch;

drivers/spi/spi-rspi.c

@@ -472,25 +472,52 @@ static int rspi_dma_transfer(struct rspi_data *rspi, struct sg_table *tx,
 	dma_cookie_t cookie;
 	int ret;
 
-	if (tx) {
-		desc_tx = dmaengine_prep_slave_sg(rspi->master->dma_tx,
-					tx->sgl, tx->nents, DMA_TO_DEVICE,
-					DMA_PREP_INTERRUPT | DMA_CTRL_ACK);
-		if (!desc_tx)
-			goto no_dma;
-
-		irq_mask |= SPCR_SPTIE;
-	}
+	/* First prepare and submit the DMA request(s), as this may fail */
 	if (rx) {
 		desc_rx = dmaengine_prep_slave_sg(rspi->master->dma_rx,
 					rx->sgl, rx->nents, DMA_FROM_DEVICE,
 					DMA_PREP_INTERRUPT | DMA_CTRL_ACK);
-		if (!desc_rx)
-			goto no_dma;
+		if (!desc_rx) {
+			ret = -EAGAIN;
+			goto no_dma_rx;
+		}
+
+		desc_rx->callback = rspi_dma_complete;
+		desc_rx->callback_param = rspi;
+		cookie = dmaengine_submit(desc_rx);
+		if (dma_submit_error(cookie)) {
+			ret = cookie;
+			goto no_dma_rx;
+		}
 
 		irq_mask |= SPCR_SPRIE;
 	}
 
+	if (tx) {
+		desc_tx = dmaengine_prep_slave_sg(rspi->master->dma_tx,
+					tx->sgl, tx->nents, DMA_TO_DEVICE,
+					DMA_PREP_INTERRUPT | DMA_CTRL_ACK);
+		if (!desc_tx) {
+			ret = -EAGAIN;
+			goto no_dma_tx;
+		}
+
+		if (rx) {
+			/* No callback */
+			desc_tx->callback = NULL;
+		} else {
+			desc_tx->callback = rspi_dma_complete;
+			desc_tx->callback_param = rspi;
+		}
+		cookie = dmaengine_submit(desc_tx);
+		if (dma_submit_error(cookie)) {
+			ret = cookie;
+			goto no_dma_tx;
+		}
+
+		irq_mask |= SPCR_SPTIE;
+	}
+
 	/*
 	 * DMAC needs SPxIE, but if SPxIE is set, the IRQ routine will be
 	 * called. So, this driver disables the IRQ while DMA transfer.
@@ -503,34 +530,24 @@ static int rspi_dma_transfer(struct rspi_data *rspi, struct sg_table *tx,
 	rspi_enable_irq(rspi, irq_mask);
 	rspi->dma_callbacked = 0;
 
-	if (rx) {
-		desc_rx->callback = rspi_dma_complete;
-		desc_rx->callback_param = rspi;
-		cookie = dmaengine_submit(desc_rx);
-		if (dma_submit_error(cookie))
-			return cookie;
+	/* Now start DMA */
+	if (rx)
 		dma_async_issue_pending(rspi->master->dma_rx);
-	}
-	if (tx) {
-		if (rx) {
-			/* No callback */
-			desc_tx->callback = NULL;
-		} else {
-			desc_tx->callback = rspi_dma_complete;
-			desc_tx->callback_param = rspi;
-		}
-		cookie = dmaengine_submit(desc_tx);
-		if (dma_submit_error(cookie))
-			return cookie;
+	if (tx)
 		dma_async_issue_pending(rspi->master->dma_tx);
-	}
 
 	ret = wait_event_interruptible_timeout(rspi->wait,
 					       rspi->dma_callbacked, HZ);
 	if (ret > 0 && rspi->dma_callbacked)
 		ret = 0;
-	else if (!ret)
+	else if (!ret) {
+		dev_err(&rspi->master->dev, "DMA timeout\n");
 		ret = -ETIMEDOUT;
+		if (tx)
+			dmaengine_terminate_all(rspi->master->dma_tx);
+		if (rx)
+			dmaengine_terminate_all(rspi->master->dma_rx);
+	}
 
 	rspi_disable_irq(rspi, irq_mask);
 
@@ -541,11 +558,16 @@ static int rspi_dma_transfer(struct rspi_data *rspi, struct sg_table *tx,
 
 	return ret;
 
-no_dma:
-	pr_warn_once("%s %s: DMA not available, falling back to PIO\n",
-		     dev_driver_string(&rspi->master->dev),
-		     dev_name(&rspi->master->dev));
-	return -EAGAIN;
+no_dma_tx:
+	if (rx)
+		dmaengine_terminate_all(rspi->master->dma_rx);
+no_dma_rx:
+	if (ret == -EAGAIN) {
+		pr_warn_once("%s %s: DMA not available, falling back to PIO\n",
+			     dev_driver_string(&rspi->master->dev),
+			     dev_name(&rspi->master->dev));
+	}
+	return ret;
 }
 
 static void rspi_receive_init(const struct rspi_data *rspi)

drivers/spi/spi.c

@@ -848,6 +848,7 @@ static int spi_transfer_one_message(struct spi_master *master,
 
 /**
  * spi_finalize_current_transfer - report completion of a transfer
+ * @master: the master reporting completion
  *
  * Called by SPI drivers using the core transfer_one_message()
  * implementation to notify it that the current interrupt driven

include/linux/spi/spi.h

@@ -253,6 +253,7 @@ static inline void spi_unregister_driver(struct spi_driver *sdrv)
  *	the device whose settings are being modified.
  * @transfer: adds a message to the controller's transfer queue.
  * @cleanup: frees controller-specific state
+ * @can_dma: determine whether this master supports DMA
  * @queued: whether this master is providing an internal message queue
  * @kworker: thread struct for message pump
  * @kworker_task: pointer to task for message pump kworker thread
@@ -262,6 +263,7 @@ static inline void spi_unregister_driver(struct spi_driver *sdrv)
  * @cur_msg: the currently in-flight message
  * @cur_msg_prepared: spi_prepare_message was called for the currently
  *                    in-flight message
+ * @cur_msg_mapped: message has been mapped for DMA
  * @xfer_completion: used by core transfer_one_message()
  * @busy: message pump is busy
  * @running: message pump is running
@@ -299,6 +301,10 @@ static inline void spi_unregister_driver(struct spi_driver *sdrv)
  * @cs_gpios: Array of GPIOs to use as chip select lines; one per CS
  *	number. Any individual value may be -ENOENT for CS lines that
  *	are not GPIOs (driven by the SPI controller itself).
+ * @dma_tx: DMA transmit channel
+ * @dma_rx: DMA receive channel
+ * @dummy_rx: dummy receive buffer for full-duplex devices
+ * @dummy_tx: dummy transmit buffer for full-duplex devices
  *
  * Each SPI master controller can communicate with one or more @spi_device
  * children.  These make a small bus, sharing MOSI, MISO and SCK signals
@@ -632,6 +638,7 @@ struct spi_transfer {
  *	addresses for each transfer buffer
  * @complete: called to report transaction completions
  * @context: the argument to complete() when it's called
+ * @frame_length: the total number of bytes in the message
  * @actual_length: the total number of bytes that were transferred in all
  *	successful segments
  * @status: zero for success, else negative errno