[PATCH] 3c59x: only put the device into D3 when we're actually using WOL

During a warm boot the device is in D3 and has troubles coming out of it.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/net/3c59x.c

@@ -1581,7 +1581,8 @@ vortex_up(struct net_device *dev)
 
 	if (VORTEX_PCI(vp)) {
 		pci_set_power_state(VORTEX_PCI(vp), PCI_D0);	/* Go active */
-		pci_restore_state(VORTEX_PCI(vp));
+		if (vp->pm_state_valid)
+			pci_restore_state(VORTEX_PCI(vp));
 		pci_enable_device(VORTEX_PCI(vp));
 	}
 
@@ -2741,6 +2742,7 @@ vortex_down(struct net_device *dev, int final_down)
 		outl(0, ioaddr + DownListPtr);
 
 	if (final_down && VORTEX_PCI(vp)) {
+		vp->pm_state_valid = 1;
 		pci_save_state(VORTEX_PCI(vp));
 		acpi_set_WOL(dev);
 	}
@@ -3243,9 +3245,10 @@ static void acpi_set_WOL(struct net_device *dev)
 		outw(RxEnable, ioaddr + EL3_CMD);
 
 		pci_enable_wake(VORTEX_PCI(vp), 0, 1);
+
+		/* Change the power state to D3; RxEnable doesn't take effect. */
+		pci_set_power_state(VORTEX_PCI(vp), PCI_D3hot);
 	}
-	/* Change the power state to D3; RxEnable doesn't take effect. */
-	pci_set_power_state(VORTEX_PCI(vp), PCI_D3hot);
 }