media: i2c: imx219: fix msr access command sequence

It was reported to me that the imx219 didn't work on one of our
development kits partly because the access sequence is incorrect.
The datasheet I could find [1] for this camera has the access sequence:
Seq. No. Address (Hex) data
1        30EB          05
2        30EB          0C
3        300A          FF
4        300B          FF
5        30EB          05
6        30EB          09

but the driver swaps the first two elements. Laurent pointed out on IRC
that the original code used the correct sequence for 1920x1080 but the
current sequence for 3280x2464 and 1640x1232. During refactoring of the
init sequence the current order was used for all formats.

Switch to using the documented sequence.

Link: https://www.opensourceinstruments.com/Electronics/Data/IMX219PQ.pdf [1]
Fixes: 85084559 ("media: i2c: imx219: Split common registers from mode tables")
Fixes: 1283b3b8 ("media: i2c: Add driver for Sony IMX219 sensor")
Signed-off-by: Conor Dooley <conor.dooley@microchip.com>
Reviewed-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Tested-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Tested-by: Adam Ford <aford173@gmail.com>  #imx8mp-beacon-kit
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>

drivers/media/i2c/imx219.c

@@ -162,8 +162,8 @@ static const struct cci_reg_sequence imx219_common_regs[] = {
 	{ IMX219_REG_MODE_SELECT, 0x00 },	/* Mode Select */
 
 	/* To Access Addresses 3000-5fff, send the following commands */
-	{ CCI_REG8(0x30eb), 0x0c },
 	{ CCI_REG8(0x30eb), 0x05 },
+	{ CCI_REG8(0x30eb), 0x0c },
 	{ CCI_REG8(0x300a), 0xff },
 	{ CCI_REG8(0x300b), 0xff },
 	{ CCI_REG8(0x30eb), 0x05 },