usb: xhci: fix uninitialized completion when USB3 port got wrong status

BugLink: https://bugs.launchpad.net/bugs/1810967

commit 958c0bd8 upstream.

Realtek USB3.0 Card Reader [0bda:0328] reports wrong port status on
Cannon lake PCH USB3.1 xHCI [8086:a36d] after resume from S3,
after clear port reset it works fine.

Since this device is registered on USB3 roothub at boot,
when port status reports not superspeed, xhci_get_port_status will call
an uninitialized completion in bus_state[0].
Kernel will hang because of NULL pointer.

Restrict the USB2 resume status check in USB2 roothub to fix hang issue.

Cc: stable@vger.kernel.org
Signed-off-by: Aaron Ma <aaron.ma@canonical.com>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Juerg Haefliger <juergh@canonical.com>
Signed-off-by: Kleber Sacilotto de Souza <kleber.souza@canonical.com>

drivers/usb/host/xhci-hub.c

@@ -753,7 +753,7 @@ static u32 xhci_get_port_status(struct usb_hcd *hcd,
 			status |= USB_PORT_STAT_SUSPEND;
 	}
 	if ((raw_port_status & PORT_PLS_MASK) == XDEV_RESUME &&
-		!DEV_SUPERSPEED_ANY(raw_port_status)) {
+		!DEV_SUPERSPEED_ANY(raw_port_status) && hcd->speed < HCD_USB3) {
 		if ((raw_port_status & PORT_RESET) ||
 				!(raw_port_status & PORT_PE))
 			return 0xffffffff;

drivers/usb/host/xhci-ring.c

@@ -1673,7 +1673,7 @@ static void handle_port_status(struct xhci_hcd *xhci,
 	 * RExit to a disconnect state).  If so, let the the driver know it's
 	 * out of the RExit state.
 	 */
-	if (!DEV_SUPERSPEED_ANY(temp) &&
+	if (!DEV_SUPERSPEED_ANY(temp) && hcd->speed < HCD_USB3 &&
 			test_and_clear_bit(faked_port_index,
 				&bus_state->rexit_ports)) {
 		complete(&bus_state->rexit_done[faked_port_index]);