Commit 3ec0a0f1 authored by Harini Katakam's avatar Harini Katakam Committed by David S. Miller

net: marvell: Add separate config ANEG function for Marvell 88E1111

Marvell 88E1111 currently uses the generic marvell config ANEG function.
This function has a sequence accessing Page 5 and Register 31,
both of which are not defined or reserved for this PHY.
Hence this patch adds a new config ANEG function for Marvell 88E1111
without these erroneous accesses.
Signed-off-by: default avatarHarini Katakam <harinik@xilinx.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent d10f0b31
......@@ -285,6 +285,48 @@ static int marvell_config_aneg(struct phy_device *phydev)
return 0;
}
static int m88e1111_config_aneg(struct phy_device *phydev)
{
int err;
/* The Marvell PHY has an errata which requires
* that certain registers get written in order
* to restart autonegotiation
*/
err = phy_write(phydev, MII_BMCR, BMCR_RESET);
err = marvell_set_polarity(phydev, phydev->mdix);
if (err < 0)
return err;
err = phy_write(phydev, MII_M1111_PHY_LED_CONTROL,
MII_M1111_PHY_LED_DIRECT);
if (err < 0)
return err;
err = genphy_config_aneg(phydev);
if (err < 0)
return err;
if (phydev->autoneg != AUTONEG_ENABLE) {
int bmcr;
/* A write to speed/duplex bits (that is performed by
* genphy_config_aneg() call above) must be followed by
* a software reset. Otherwise, the write has no effect.
*/
bmcr = phy_read(phydev, MII_BMCR);
if (bmcr < 0)
return bmcr;
err = phy_write(phydev, MII_BMCR, bmcr | BMCR_RESET);
if (err < 0)
return err;
}
return 0;
}
#ifdef CONFIG_OF_MDIO
/*
* Set and/or override some configuration registers based on the
......@@ -1175,7 +1217,7 @@ static struct phy_driver marvell_drivers[] = {
.flags = PHY_HAS_INTERRUPT,
.probe = marvell_probe,
.config_init = &m88e1111_config_init,
.config_aneg = &marvell_config_aneg,
.config_aneg = &m88e1111_config_aneg,
.read_status = &marvell_read_status,
.ack_interrupt = &marvell_ack_interrupt,
.config_intr = &marvell_config_intr,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment