Commit 3edfb7bd authored by Ricardo Ribalda Delgado's avatar Ricardo Ribalda Delgado Committed by Linus Walleij

gpiolib: Show correct direction from the beginning

Current code assumes that the direction is input if direction_input
function is set.
This might not be the case on GPIOs with programmable direction.
Signed-off-by: default avatarRicardo Ribalda Delgado <ricardo.ribalda@gmail.com>
Tested-by: default avatarJeffrey Hugo <jhugo@codeaurora.org>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 6f0ec09a
...@@ -1351,20 +1351,6 @@ int gpiochip_add_data_with_key(struct gpio_chip *chip, void *data, ...@@ -1351,20 +1351,6 @@ int gpiochip_add_data_with_key(struct gpio_chip *chip, void *data,
spin_unlock_irqrestore(&gpio_lock, flags); spin_unlock_irqrestore(&gpio_lock, flags);
for (i = 0; i < chip->ngpio; i++) {
struct gpio_desc *desc = &gdev->descs[i];
desc->gdev = gdev;
/* REVISIT: most hardware initializes GPIOs as inputs (often
* with pullups enabled) so power usage is minimized. Linux
* code should set the gpio direction first thing; but until
* it does, and in case chip->get_direction is not set, we may
* expose the wrong direction in sysfs.
*/
desc->flags = !chip->direction_input ? (1 << FLAG_IS_OUT) : 0;
}
#ifdef CONFIG_PINCTRL #ifdef CONFIG_PINCTRL
INIT_LIST_HEAD(&gdev->pin_ranges); INIT_LIST_HEAD(&gdev->pin_ranges);
#endif #endif
...@@ -1393,6 +1379,19 @@ int gpiochip_add_data_with_key(struct gpio_chip *chip, void *data, ...@@ -1393,6 +1379,19 @@ int gpiochip_add_data_with_key(struct gpio_chip *chip, void *data,
if (status) if (status)
goto err_remove_chip; goto err_remove_chip;
for (i = 0; i < chip->ngpio; i++) {
struct gpio_desc *desc = &gdev->descs[i];
desc->gdev = gdev;
if (chip->get_direction && gpiochip_line_is_valid(chip, i))
desc->flags = !chip->get_direction(chip, i) ?
(1 << FLAG_IS_OUT) : 0;
else
desc->flags = !chip->direction_input ?
(1 << FLAG_IS_OUT) : 0;
}
acpi_gpiochip_add(chip); acpi_gpiochip_add(chip);
machine_gpiochip_add(chip); machine_gpiochip_add(chip);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment