i2c: omap: raw read and write endian fix

All OMAP IP blocks expect LE data, but CPU may operate in BE mode.
Need to use endian neutral functions to read/write h/w registers.
I.e instead of __raw_read[lw] and __raw_write[lw] functions code
need to use read[lw]_relaxed and write[lw]_relaxed functions.
If the first simply reads/writes register, the second will byteswap
it if host operates in BE mode.

Changes are trivial sed like replacement of __raw_xxx functions
with xxx_relaxed variant.
Signed-off-by: Victor Kamensky <victor.kamensky@linaro.org>
Signed-off-by: Taras Kondratiuk <taras.kondratiuk@linaro.org>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-omap.c

@@ -266,13 +266,13 @@ static const u8 reg_map_ip_v2[] = {
 static inline void omap_i2c_write_reg(struct omap_i2c_dev *i2c_dev,
 				      int reg, u16 val)
 {
-	__raw_writew(val, i2c_dev->base +
+	writew_relaxed(val, i2c_dev->base +
 			(i2c_dev->regs[reg] << i2c_dev->reg_shift));
 }
 
 static inline u16 omap_i2c_read_reg(struct omap_i2c_dev *i2c_dev, int reg)
 {
-	return __raw_readw(i2c_dev->base +
+	return readw_relaxed(i2c_dev->base +
 				(i2c_dev->regs[reg] << i2c_dev->reg_shift));
 }
 
@@ -1140,9 +1140,9 @@ omap_i2c_probe(struct platform_device *pdev)
 	 * Read the Rev hi bit-[15:14] ie scheme this is 1 indicates ver2.
 	 * On omap1/3/2 Offset 4 is IE Reg the bit [15:14] is 0 at reset.
 	 * Also since the omap_i2c_read_reg uses reg_map_ip_* a
-	 * raw_readw is done.
+	 * readw_relaxed is done.
 	 */
-	rev = __raw_readw(dev->base + 0x04);
+	rev = readw_relaxed(dev->base + 0x04);
 
 	dev->scheme = OMAP_I2C_SCHEME(rev);
 	switch (dev->scheme) {