enic: do not call enic_change_mtu in enic_probe

commit cb5c6568 upstream.

In commit ab123fe0 ("enic: handle mtu change for vf properly")
ASSERT_RTNL() is added to _enic_change_mtu() to prevent it from being
called without rtnl held. enic_probe() calls enic_change_mtu()
without rtnl held. At this point netdev is not registered yet.
Remove call to enic_change_mtu and assign the mtu to netdev->mtu.

Fixes: ab123fe0 ("enic: handle mtu change for vf properly")
Signed-off-by: Govindarajulu Varadarajan <gvaradar@cisco.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Cc: Ben Hutchings <ben.hutchings@codethink.co.uk>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/net/ethernet/cisco/enic/enic_main.c

@@ -2681,7 +2681,6 @@ static int enic_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 	 */
 
 	enic->port_mtu = enic->config.mtu;
-	(void)enic_change_mtu(netdev, enic->port_mtu);
 
 	err = enic_set_mac_addr(netdev, enic->mac_addr);
 	if (err) {
@@ -2731,6 +2730,7 @@ static int enic_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 		netdev->features |= NETIF_F_HIGHDMA;
 
 	netdev->priv_flags |= IFF_UNICAST_FLT;
+	netdev->mtu = enic->port_mtu;
 
 	err = register_netdev(netdev);
 	if (err) {