rtc: ds1307: apply DS13XX_TRICKLE_CHARGER_MAGIC only conditionally

DS13XX_TRICKLE_CHARGER_MAGIC sets the trickle-charge select (TCS) bits
(7..4). The datasheet of Maxim Integrated's DS1339 [1] for instance
reads:

"To prevent accidental enabling, only a pattern on 1010 enables the
trickle charger. All other patterns disable the trickle charger."

Since not all RTCs connected to a backup battery or supercap use these
bits DS13XX_TRICKLE_CHARGER_MAGIC should not get applied for all charger
setups unconditionally.
Epson's RX8130 is such an example: Instead of TCS bits "SMPTSEL1",
"SMPTSEL0",  "CHGEN" and "INIEN" are expected as bit 7..4.

DS1339 and DS1340 are currently the only RTCs in the ds1307 driver that
apply DS13XX_TRICKLE_CHARGER_MAGIC to their setup register value. So
apply DS13XX_TRICKLE_CHARGER_MAGIC in do_trickle_setup_ds1339() which
is used by both RTCs.

[1] https://datasheets.maximintegrated.com/en/ds/DS1339-DS1339U.pdf
[2] https://support.epson.biz/td/api/doc_check.php?dl=app_RX8130CESigned-off-by: Bastian Krause <bst@pengutronix.de>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Link: https://lore.kernel.org/r/20200917183246.19446-5-bst@pengutronix.de

drivers/rtc/rtc-ds1307.c

@@ -512,6 +512,8 @@ static u8 do_trickle_setup_ds1339(struct ds1307 *ds1307, u32 ohms, bool diode)
 	u8 setup = (diode) ? DS1307_TRICKLE_CHARGER_DIODE :
 		DS1307_TRICKLE_CHARGER_NO_DIODE;
 
+	setup |= DS13XX_TRICKLE_CHARGER_MAGIC;
+
 	switch (ohms) {
 	case 250:
 		setup |= DS1307_TRICKLE_CHARGER_250_OHM;
@@ -1763,7 +1765,6 @@ static int ds1307_probe(struct i2c_client *client,
 		trickle_charger_setup = pdata->trickle_charger_setup;
 
 	if (trickle_charger_setup && chip->trickle_charger_reg) {
-		trickle_charger_setup |= DS13XX_TRICKLE_CHARGER_MAGIC;
 		dev_dbg(ds1307->dev,
 			"writing trickle charger info 0x%x to 0x%x\n",
 			trickle_charger_setup, chip->trickle_charger_reg);