Commit 48a30569 authored by Michael Chan's avatar Michael Chan Committed by David S. Miller

cnic: Fix crash in cnic_bnx2x_service_kcq()

commit 104a43ed
    cnic: Use CHIP_NUM macros from bnx2x.h

changed the code to use the bnx2x macro NO_FCOE() to determine if FCoE
is supported or not.  There is another place in cnic that is still using
the old method to determine if FCoE is supported or not.  The 2 methods
may not yield the same result after the network interface is brought down
and up.  This will cause the crash as cnic_bnx2x_service_kcq() will access
the uninitialized cp->kcq2.

The fix is to consistently use the same macro CNIC_SUPPORTS_FCOE() which
uses the bnx2x NO_FCOE() macro.  As a follow-up, we can clean up the code
to remove the old method as it is no longer needed.
Signed-off-by: default avatarMichael Chan <mchan@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent f78afb35
......@@ -3135,6 +3135,7 @@ static void cnic_service_bnx2x_bh(unsigned long data)
{
struct cnic_dev *dev = (struct cnic_dev *) data;
struct cnic_local *cp = dev->cnic_priv;
struct bnx2x *bp = netdev_priv(dev->netdev);
u32 status_idx, new_status_idx;
if (unlikely(!test_bit(CNIC_F_CNIC_UP, &dev->flags)))
......@@ -3146,7 +3147,7 @@ static void cnic_service_bnx2x_bh(unsigned long data)
CNIC_WR16(dev, cp->kcq1.io_addr,
cp->kcq1.sw_prod_idx + MAX_KCQ_IDX);
if (cp->ethdev->drv_state & CNIC_DRV_STATE_NO_FCOE) {
if (!CNIC_SUPPORTS_FCOE(bp)) {
cp->arm_int(dev, status_idx);
break;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment