Commit 49d10347 authored by hayeswang's avatar hayeswang Committed by David S. Miller

r8152: move the default coalesce setting for RTL8153

Only RTL8153 could set coalesce, so move the default setting for
rtl8152_probe() to r8153_init().
Signed-off-by: default avatarHayes Wang <hayeswang@realtek.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 3cb3234e
...@@ -3579,6 +3579,19 @@ static void r8153_init(struct r8152 *tp) ...@@ -3579,6 +3579,19 @@ static void r8153_init(struct r8152 *tp)
ocp_write_word(tp, MCU_TYPE_USB, USB_USB_CTRL, ocp_data); ocp_write_word(tp, MCU_TYPE_USB, USB_USB_CTRL, ocp_data);
rtl_tally_reset(tp); rtl_tally_reset(tp);
switch (tp->udev->speed) {
case USB_SPEED_SUPER:
case USB_SPEED_SUPER_PLUS:
tp->coalesce = COALESCE_SUPER;
break;
case USB_SPEED_HIGH:
tp->coalesce = COALESCE_HIGH;
break;
default:
tp->coalesce = COALESCE_SLOW;
break;
}
} }
static int rtl8152_pre_reset(struct usb_interface *intf) static int rtl8152_pre_reset(struct usb_interface *intf)
...@@ -4524,19 +4537,6 @@ static int rtl8152_probe(struct usb_interface *intf, ...@@ -4524,19 +4537,6 @@ static int rtl8152_probe(struct usb_interface *intf,
tp->mii.reg_num_mask = 0x1f; tp->mii.reg_num_mask = 0x1f;
tp->mii.phy_id = R8152_PHY_ID; tp->mii.phy_id = R8152_PHY_ID;
switch (udev->speed) {
case USB_SPEED_SUPER:
case USB_SPEED_SUPER_PLUS:
tp->coalesce = COALESCE_SUPER;
break;
case USB_SPEED_HIGH:
tp->coalesce = COALESCE_HIGH;
break;
default:
tp->coalesce = COALESCE_SLOW;
break;
}
tp->autoneg = AUTONEG_ENABLE; tp->autoneg = AUTONEG_ENABLE;
tp->speed = tp->mii.supports_gmii ? SPEED_1000 : SPEED_100; tp->speed = tp->mii.supports_gmii ? SPEED_1000 : SPEED_100;
tp->duplex = DUPLEX_FULL; tp->duplex = DUPLEX_FULL;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment