Commit 4a80f776 authored by Jun Nie's avatar Jun Nie Committed by Ulf Hansson

Documentation: synopsys-dw-mshc: add binding for fifo quirks

Add fifo-addr property and fifo-watermark-quirk property to
synopsys-dw-mshc bindings. It is intended to provide more
dt interface to support SoCs specific configuration.
Signed-off-by: default avatarJun Nie <jun.nie@linaro.org>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarJaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent b8789ec4
...@@ -75,6 +75,17 @@ Optional properties: ...@@ -75,6 +75,17 @@ Optional properties:
* card-detect-delay: Delay in milli-seconds before detecting card after card * card-detect-delay: Delay in milli-seconds before detecting card after card
insert event. The default value is 0. insert event. The default value is 0.
* data-addr: Override fifo address with value provided by DT. The default FIFO reg
offset is assumed as 0x100 (version < 0x240A) and 0x200(version >= 0x240A) by
driver. If the controller does not follow this rule, please use this property
to set fifo address in device tree.
* fifo-watermark-aligned: Data done irq is expected if data length is less than
watermark in PIO mode. But fifo watermark is requested to be aligned with data
length in some SoC so that TX/RX irq can be generated with data done irq. Add this
watermark quirk to mark this requirement and force fifo watermark setting
accordingly.
* vmmc-supply: The phandle to the regulator to use for vmmc. If this is * vmmc-supply: The phandle to the regulator to use for vmmc. If this is
specified we'll defer probe until we can find this regulator. specified we'll defer probe until we can find this regulator.
...@@ -102,6 +113,8 @@ board specific portions as listed below. ...@@ -102,6 +113,8 @@ board specific portions as listed below.
interrupts = <0 75 0>; interrupts = <0 75 0>;
#address-cells = <1>; #address-cells = <1>;
#size-cells = <0>; #size-cells = <0>;
data-addr = <0x200>;
fifo-watermark-aligned;
resets = <&rst 20>; resets = <&rst 20>;
reset-names = "reset"; reset-names = "reset";
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment