Commit 4bcc56bb authored by Johannes Berg's avatar Johannes Berg

mac80211: ask driver to look at power level when starting AP

The power level might have been set, but as the interface was idle
it might not have taken effect yet. Ask the driver to check the
power level when starting up an AP so that in this case the correct
power level is used in case the device/driver can only set it when
the interface is actually active.
Signed-off-by: default avatarJohannes Berg <johannes.berg@intel.com>
parent 5cf16616
...@@ -678,7 +678,8 @@ static int ieee80211_start_ap(struct wiphy *wiphy, struct net_device *dev, ...@@ -678,7 +678,8 @@ static int ieee80211_start_ap(struct wiphy *wiphy, struct net_device *dev,
BSS_CHANGED_BEACON_ENABLED | BSS_CHANGED_BEACON_ENABLED |
BSS_CHANGED_BEACON | BSS_CHANGED_BEACON |
BSS_CHANGED_SSID | BSS_CHANGED_SSID |
BSS_CHANGED_P2P_PS; BSS_CHANGED_P2P_PS |
BSS_CHANGED_TXPOWER;
int err; int err;
old = sdata_dereference(sdata->u.ap.beacon, sdata); old = sdata_dereference(sdata->u.ap.beacon, sdata);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment